Allen & Heath SQ Dante Bedienungsanleitung

Lies die bedienungsanleitung für Allen & Heath SQ Dante (2 Seiten) kostenlos online; sie gehört zur Kategorie Prozessor. Dieses Handbuch wurde von 41 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 21 Bewertungen. Hast du eine Frage zu Allen & Heath SQ Dante oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

M--SDANTE Fitting Note SQ

AP11431 Issue 2

SQ Dante Option Card

M--SDANTE is one of several audio networking options that can be fitted to SQ

an Allen & Heath mixer. It provides a 64x64ch 48/96kHz interface to a Dante SQ

network.

Fitting the card

1.Switch the system off.

2.Use a Torx T8 driver to remove the 2 screws securing the I/O Port

blank panel the SQ mixer. to

3.Slide the card into the slot and press it firmly into the mating

connector.

4.Refit the 2 screws to secure the card.

Control Network Bridge

Go to the screen to switch on Control Setup / Audio I/O Port/

Network Bridge. This connects the SQ Network Port and I/O Port

control networks.

 The Control Network Bridge does not pass audio.

 Connecting to a network that includes a DHCP server

(such as a router) can change the IP address of the Dante

card. Therefore it is recommended that the network is

only bridged when necessary.

Software and firmware

Download and install the latest version of firmware: SQ

http://www.allen-heath.com/sq-software

 M--SDANTE requires firmware V1.2.2 or above. SQSQ

Go to the Audinate website to learn more about Dante, and to download software

including Dante Controller and Dante Virtual Soundcard (DVS):

http://www.audinate.com/

Produktspezifikationen