Amerock H55445ORB Bedienungsanleitung

Lies die bedienungsanleitung für Amerock H55445ORB (3 Seiten) kostenlos online; sie gehört zur Kategorie Kleiderschrank. Dieses Handbuch wurde von 10 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 7 Bewertungen. Hast du eine Frage zu Amerock H55445ORB oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Installing New Cabinet Hardware

Step 1.Location of Cabinet Hardware

While there are no hard, fast rules for placement of a knob or pull on a cabinet door, most cabinet makers will locate them

approximately 3"-4" above the upper non-hinged corner on base cabinets, or the lower non-hinged corner on wall cabinets.

However, the decision is your to make!

Wall CabinetsBase Cabinets

Wall or

Base Cabinets

Drawers

Step 2.Mounting Cabinet Hardware

When drilling for a knob or pull, a 3/16" hole is recommended for most styles. The exception is pulls that have "studs".

A stud is simply an extension of the molded screw holes. If a pull has a stud, then a 1/4" hole is required with studs sitting

securely in the wood.

IMPORTANTScrew Information

Amerock

®

includes 8-32 x 1" long machine screws with most knobs and pulls because the typical cabinet door or drawer front

is 3/4" thick. This screw length should work in most applications. However, if your cabinet doors or drawer fronts are thicker

than 3/4", then you will need to use longer screws for mounting. Check the thickness of both a cabinet door and a drawer front

in your kitchen, as the thickness dimensions may not be the same. In general, the screw length(s) used should be 1/4" longer

than the thickness of your cabinet door or drawer front material. It is not uncommon for some drawers to be constructed with a

3/4" thick front attached to a 3/4" thick drawer box. In this situation, the total drawer thickness is 1-1/2", making a 1-3/4" long

screw necessary for mounting. These screws may be purchased from any hardware store. Please note that select hardware sold

by Amerock may include metric screws instead of UNC screws.

Produktspezifikationen