AMX VARIA-ACS-100F Bedienungsanleitung

Lies die bedienungsanleitung für AMX VARIA-ACS-100F (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 41 Personen als hilfreich bewertet und erhielt im Schnitt 4.1 Sterne aus 8 Bewertungen. Hast du eine Frage zu AMX VARIA-ACS-100F oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

QUICK START GUIDE

VARIA-ACS-80F 8” Fixed Tabletop Stand

VARIA-ACS-100F

10.1” Fixed Tabletop Stand

Overview

TheVariaFixed Tabletop stands are designed for 8” VARIA-80 & 10.1” VARIA-100

Touch Panels, and give them a sturdy & stylish fixed-angle tabletop solution

that’s reminiscent of AMX’s Modero touch panel family.

FIG. 1VariaTouch Panel on Fixed Tabletop Stand

Model Availability & Compatibility

FIXED TABLETOP STANDS

VARIA-ACS-80F

(AMX-UMT0801)

VARIA-80 Touch Panel (AMX-UTP0811)

VARIA-ACS-100F

(AMX-UMT1001)

VARIA-100 Touch Panel (AMX-UTP1011)

VARIA-100N Touch Panel (AMX-UTP1011N)

Other Models Available

ANGLE-SELECT TABLETOP STANDS

VARIA-ACS-810A

(AMX-UMT8111)

VARIA-80 Touch Panel (AMX-UTP0811)

VARIA-100 Touch Panel (AMX-UTP1011)

VARIA-100N Touch Panel (AMX-UTP1011N)

VARIA-ACS-150A

(AMX-UMT1511)

VARIA-150 Touch Panel (AMX-UTP1511)

VARIA-150N Touch Panel (AMX-UTP1511N)

Installation

VariaFixed Tabletop Stands are easily installed with the supplied hardware and

a Philips-head screwdriver.

1.Place the panel face-down on a soft cloth, and orient the panel so

that the top of the touch panel is closest to you.

FIG. 2Varia Touch Panel, rear

2.If they are installed, remove two screws from the lower back cover.

Screw Locations

FIG. 3Rear cover screws, if installed

3.Place your thumbs onthe rectangular access holes, and push the

lower cover away from you.The lower cover can thenbe placed

aside; it is not used with the Fixed Tabletop Stands.

FIG. 4 Rear cover removal

4.Rotatethe panel back around so the bottom is closest to you.

5.On the tabletop stand, remove the black plastic cover by sliding it

away from the aluminum base. It is held on by magnets. Then

unscrew the rubber pads from the base.

6.Install the aluminum base on the back o the touch panel.

Note:In mostcircumstances, the networking cable can be routed in

after base installation. However, category cables with bulky strain

relief and/or hoods over the RJ-45 connector may need to be installed

before the aluminum base.

FIG.5Fixed Tabletop Stand, aluminum base, underneath

7.Attach the base with the four (4) supplied screws.

Top

Top

Produktspezifikationen