Andrews PAC22 Series 2 Bedienungsanleitung

Lies die bedienungsanleitung für Andrews PAC22 Series 2 (3 Seiten) kostenlos online; sie gehört zur Kategorie Klimaanlage. Dieses Handbuch wurde von 45 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 23 Bewertungen. Hast du eine Frage zu Andrews PAC22 Series 2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Clickwww.andrews-sykes.com

or Call Us Free 0800 211 611

PAC22 Series 2

Portable Air Conditioning

Operating Instructions

& Safety Guide

General Safety

Keep children and animals away from air conditioning units.

Never leave them alone in a room where the units in use.

This equipment should only be used by a competent person who

has read and understood these instructions.

Never operate this equipment if you are ill, feeling tired or under the

influence of alcohol or drugs.

Keep the Air Conditioning vents clear of all obstructions.

Never put anything on top of the unit or block the air outlets.

Make sure equipment is switched off and unplugged after use.

Never leave switched on or unattended.

Do not use the unit where sunlight is shining directly onto it.

Check condition of equipment before use. If unit is showing signs

of damage contact your supplier immediately.

Electrical Safety

This unit requires a 230 volt electrical supply. It plugs into a standard BS1363

domestic socket.

Always inspect plugs and leads for damage before plugging into the supply -

DO NOT USE IF ANY DAMAGE IS FOUND

Ensure cables are run as not to cause a hazard.

If an extension lead is used, ensure it is of the correct standard , and fully

uncoiled when being used.

Do not lay electrical cables in wet / damp areas.

Do not move equipment whilst operating.

Do not pull equipment by its cable.

It is recommended that electrical equipment is used via a suitable RCD.

Machine not working?

ONLY A COMPETENT ELECTRICIAN SHOULD ATTEMPT TO RECTIFY

ELECTRICAL SUPPLY PROBLEMS. DO NOT REMOVE ANY PANELS FROM THE

MACHINE.

SERIES 2

ProblemLikely CauseSolution

No air flow from the

room unit

Red ‘MAINS’ light offTurn on electricity and/or check mains

supply fuse

No air flow from the

room unit

Red ‘MAINS’ light on.

White ‘DEFROST’

light on

Machine is in defrost mode, do not

adjust anything, machine will revert to

normal run after 10 mins

Insufficient air flow

from the room unit

Blocked air filterClean filter

No coolingGreen ‘COOLING’

light off

Revolve thermostat knob fully anti-

clockwise to ‘1’. Wait 10 minutes for

time delay on start-up.

No coolingAmber ‘ATTENTION’

light illuminated. High

pressure trip.

Press ‘+’ button to re-set and check for:

Lack of water flow... kinked hoses?

Shortage of water..... top up.

External heat exchanger unit mounted in

very high temperature?

Water frozen? Add glycol (33%)

External heat exchanger coil blocked

with dirt.... clean

Air cooled units.... lack of air flow from

exhaust.... kinked or blocked duct, duct

too long.

No coolingAmber ‘ATTENTION’

light illuminated. Low

pressure trip.

Press ‘-’ button to re-set and check for:

No air flow, blocked filter?

Evaporator blocked with ice. Very low air

temperature?

No coolingAmber ‘ATTENTION’

light illuminated. High

level condensate trip.

Condensate pump not reducing water

level. Kink in condensate tube between

room unit and external heat exchanger?

Leak inside room unit. Pump filter inside

room unit blocked. Condensate tube frozen

Produktspezifikationen