APart MA200CDR Bedienungsanleitung

APart Empfänger MA200CDR

Lies die bedienungsanleitung für APart MA200CDR (16 Seiten) kostenlos online; sie gehört zur Kategorie Empfänger. Dieses Handbuch wurde von 17 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 9 Bewertungen. Hast du eine Frage zu APart MA200CDR oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF

Seite 1/16

Safety First!

• Read all documentation before operating your equipment.

• Retain all documentation for future reference.

• Save the carton and packing material even if the equipment has arrived in good condition.

Should you ever need to ship the unit, use only the original factory packing.

• Do not spill water or other liquids into or on the unit.

• Make sure power outlets conform to the power requirements listed on the back of the unit.

• Do not use the unit if the electrical power cord is frayed or broken.

• Always operate the unit with the AC ground wire connected to the electrical system ground.

• Have gain controls on ampliers turned down during power-up to prevent

speaker damage if there are high signal levels at the inputs.

• Do not connect the inputs / outputs of ampliers or consoles to any other voltage source, such

as a battery, mains source, or power supply, regardless of whether the amplier or console is

turned on or off.

• Power down & disconnect units from mains voltage before making connections.

• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.

• Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an

environment which may distort the normal ow of air around the unit. If the unit is used in an

Extremely dusty or smoky environment, the unit should be periodically “blown free” of dust.

• Do not remove the cover. Removing the cover will expose you to potentially dangerous volt-

ages.

• Do not drive the inputs with a signal level greater than that required to drive equipment to full

output.

• Do not run the output of any amplier back into another input.

• Do not ground the red output terminal, never connect a red output terminal to another red

output terminal.

• In case of mal-function this device should be serviced by qualied service personnel only.

Content

1. APart MA200CDR Mixing Amplier

2. Front Panel

3. Rear Panel

4.Tuner Controls

5. Inside Settings

6. Overview Of The MA200 Series

7. How To Deal With 100V Loudspeakers Systems

8. Technical Specications

9. Block Diagram

Produktspezifikationen

Marke:	APart
Kategorie:	Empfänger
Modell:	MA200CDR
Gewicht:	13500 g
Produktfarbe:	Schwarz
Übertragungstechnik:	Kabelgebunden
Digitales UKW-Radio:	87.5 - 108 MHz
Radio Data System (RDS):	Ja
RMS-Leistung:	200 W
Energiebedarf:	230/115 V, 24V DC
Rauschverhältnis (SNR):	95 dB
Frequenzbereich:	40 - 25000 Hz
Abmessungen (BxTxH):	430 x 356 x 88 mm
AM-Bandbereich:	531 - 1602 kHz
Line-out:	Ja
Line-in:	Ja
Verzerrung und Rauschen (1 kHz):	-6 dB