APC Back- 750VA Bedienungsanleitung

Lies die bedienungsanleitung für APC Back- 750VA (8 Seiten) kostenlos online; sie gehört zur Kategorie UPS. Dieses Handbuch wurde von 61 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 2 Bewertungen. Hast du eine Frage zu APC Back- 750VA oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Installation and Operation

Back-UPS® BE750G Series

Safety

Specifications

This unit is intended for indoor use only.

Do not operate this unit in direct sunlight, in contact with fluids, or where there

is excessive dust or humidity.

Connect the Back-UPS power cord directly to a wall outlet. Do not use a surge

protector or an extension cord.

Input

Voltage120 VacNominal

Frequency50 Hz/60 Hz auto sensing

Brownout Transfers92 Vrms Typical

Over-voltage Transfer139 Vrms Typical

Output

UPS Capacity

(5 battery backup outlets)750 VA, 450 W

Total Amperage (all outlets)12 A (including UPS output)

Voltage - On Battery115 Vrms ± 8% step approximated sine wave

Frequency - On Battery50 Hz/60 Hz ± 1 Hz

Transfer Time6 ms Typical, 10 ms maximum

Protection and

Filtering

AC Surge ProtectionFull time, 354 Joules

Phone/DSL/FAX surge protectionSingle line (2 wire)

Cable/CAT V/DSS surge protectionOne coax input/output

Network surge protection10/100 Base -T ethernet

EMI/RFI FilterFull time

AC InputResettable circuit breaker

Battery

TypeSealed, maintenance-free, lead acid

Replacement battery cartridge RBC17

Average Life3 - 5 years depending on the number of discharge cycles and

environmental temperature

Physical

Net Weight11 lb (5 kg)

Dimensions

Length x Width x Height14 in x 7 in x 4 in

36 cm x 18 cm x 9 cm

Operating Temperature32º F to 104º F (0º C to 40º C)

Storage Temperature5º F to 113º F (–15º C to 45º C)

Operating Relative Humidity0 to 95% non-condensing humidity

Operating Elevation0 to 10,000 ft (0 to 3000 m)

EMC

Compliance

This device complies with part 68 and part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that may cause undesired operation.

Produktspezifikationen