APC SMX2200HVNC Bedienungsanleitung

APC Server SMX2200HVNC

Lies die bedienungsanleitung für APC SMX2200HVNC (10 Seiten) kostenlos online; sie gehört zur Kategorie Server. Dieses Handbuch wurde von 24 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 12.5 Bewertungen. Hast du eine Frage zu APC SMX2200HVNC oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF

Seite 1/10

Installation Guide Smart-UPS™ X

2000/2200/3000 VA Tower/Rack-Mount 4U

Important Safety Messages

Read the instructions carefully to become familiar with the equipment before trying to install, operate,

service or maintain it. The following special messages may appear throughout this manual or on the

equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a

procedure.

The addition of this symbol to a Caution product safety label indicates that a hazard exists that can result in

injury and product damage if the instructions are not followed.

The following safety messages may appear throughout this manual to warn of potential hazards.

Safety and General Information

Read the Safety Guide supplied with this unit before installing the UPS.

• Adhere to all local and national electrical codes.

• This UPS is intended for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or

humidity.

• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.

• The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated

ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten

battery life.

• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.

• The batteries are heavy. Remove the batteries prior to installing the UPS in a rack.

• Always install external battery packs (XLBPs) at the bottom of the rack. The UPS must be installed

above the XLBPs.

• The UPS display interface will recognize as many as 10 external battery packs connected to the UPS.

However there is no limit to the number of XLBPs that can be used with the UPS.

• Refer to Specifications in the Operation manual for UPS and battery weight.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or

moderate injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.

Smart-UPS X 2000/2200/3000 VA Tower/Rack-Mount 4U2

Inventory

Inspect the contents upon receipt. Notify the carrier and dealer if the unit is damaged.

Included with all models

1 pair tower stabilizer brackets

Use 8 flat head screws to secure tower stabilizer brackets to the UPS

1 pair rack-mount brackets

Use 8 flat head screws to secure rack-mount brackets to the UPS

Use 4 ornamental screws to secure rack-mount brackets to the rails

Install a cage nut in the rack to secure the top hole of each rack-mount bracket in a four post rack

Included with models that have factory installed

Network Management Cards

Rail kit

1 pair support brackets Two post racks

10 screws

Four post racks

6 screws

6 washers

1 pair rail cleats

8 pan head screws

Included with High Voltage (HV) models

Included with model SMX3000HVT

Smart-UPS X 2000/2200/3000 VA Tower/Rack-Mount 4U 3

Product Overview

Front panel features

Rear panel features

 Online LED

 Power ON/OFF button

 On Battery LED

 Site Wiring Fault LED

 Replace Battery LED

 LCD display screen

UP DOWN/ arrow keys

ENTER key

ESC key

 SmartSlot Controllable Outlet Group 3

 Chassis ground screw External battery pack connector

 UPS utility power input EPO connector

 Circuit Breaker reset Serial port

 Controllable Outlet Group 1 USB port

 Controllable Outlet Group 2

2000 VA, 120 Vac Low Voltage 3000 VA, 120 Vac Low Voltage

su0343a

APC By Schneider

Electric

su0756a

GROUP 1GROUP 2

GROUP 3

su0757a

Produktspezifikationen

Marke:	APC
Kategorie:	Server
Modell:	SMX2200HVNC
Display-Typ:	LED
Akustische Signale:	Ja
Breite:	178 mm
Tiefe:	483 mm
Gewicht:	38560 g
Mitgelieferte Kabel:	Input power cable, USB cable
Produktfarbe:	Schwarz
Akkuladezeit:	3 h
Akku-/Batterietechnologie:	Plombierte Bleisäure (VRLA)
Höhe:	432 mm
Stecker:	C20-Koppler
Anzahl USB 2.0 Anschlüsse:	1
Betriebstemperatur:	0 - 40 °C
Relative Luftfeuchtigkeit in Betrieb:	0 - 95 %
Verpackungsbreite:	586 mm
Verpackungstiefe:	633 mm
Verpackungshöhe:	330 mm
Paketgewicht:	47630 g
Zertifizierung:	CE, EAC, EN/IEC 62040-1, EN/IEC 62040-2, GS Mark, IRAM, RCM, VDE, WEEE
Anzahl Ethernet-LAN-Anschlüsse (RJ-45):	1
Warentarifnummer (HS):	85078000
Kabellänge:	2 m
Reaktionszeit:	10 ms
LED-Anzeigen:	Ja
Temperaturbereich bei Lagerung:	-15 - 45 °C
Luftfeuchtigkeit bei Lagerung:	0 - 95 %
Geräuschpegel:	55 dB
Batteriekapazität:	702 Ah
Formfaktor:	Rackmount/Tower
Web-basiertes Management:	Ja
Ausgangsspannung:	230 V
Schnellinstallationsanleitung:	Ja
Ausgangsleistung:	1980 W
Nachhaltigkeitszertifikate:	RoHS
Produkte pro Palette:	6 Stück(e)
Eingangsfrequenz:	50/60 Hz
Ressourcen-CD:	Ja
Rackmontageset:	Ja
Höhe bei Betrieb:	0 - 3000 m
Anzahl der AC-Ausgänge:	10 AC-Ausgänge
USV-Topologie:	Line-Interaktiv
Eingangs-Betriebsspannung (min):	140 V
Eingangs-Betriebsspannung (max):	280 V
Ausgangskapazität:	2.2 kVA
Ausgangs-Betriebsspannung (min):	208 V
Ausgangs-Betriebsspannung (max):	240 V
AC-Steckertypen:	C13 coupler, C19 coupler, C20 coupler
Wellenform:	Sine
Output Frequenz:	50/60 Hz
Regulierung der Ausgangsspannung:	5 %
EMI/RFI Lautstärkefilter:	Ja
Druckanstiegsschutz:	Ja
Akustische Alarm-Modi:	Batterieaustausch
Rack-Kapazität:	2U
Hot-Swap-Batterie:	Ja
Höhe bei Lagerung:	0 - 15000 m
Kaltstart:	Ja
Regulierung der Ausgangsfrequenz:	+/- 3 Hz
Notstrom Aus (EPO):	Ja
Auto-Neustart:	Ja
Automatischer Batterietest:	Ja