Behringer 902 Voltage Controlled Amplifier Bedienungsanleitung

Lies die bedienungsanleitung für Behringer 902 Voltage Controlled Amplifier (9 Seiten) kostenlos online; sie gehört zur Kategorie Hamer. Dieses Handbuch wurde von 14 Personen als hilfreich bewertet und erhielt im Schnitt 4.2 Sterne aus 3 Bewertungen. Hast du eine Frage zu Behringer 902 Voltage Controlled Amplifier oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Quick Start Guide

Controls

(1) CONTROL MODE (LIN/EXP) rocker switch toggles

between linear and logarithmic response modes.

(2) FIXED CONTROL VOLTAGE knob allows you to manually

set a control voltage.

(3) SIG IN input jacks accept audio and control signals over

cables with 3.5 mm TS connectors. These dual inputs

allow the unit to amplify two signals simultaneously.

(4) SIG OUT output jacks send out amplied audio and control

signals over cables with 3.5 mm TS connectors.

(5) CONTROL INPUTS accept control voltage signals from

other modules to change the amplication level.

(1)

(3)

(2)

(4)

(5)

Power Connection

The 902 VCA comes with the required power cable for connecting

to a standard Eurorack power supply system. Follow these steps

to connect power to the module. It is easier to make these

connections before the module has been mounted into a rack case.

1. Turn the power supply or rack case power o and

disconnect the power cable.

2. Insert the 16-pin connector on the power cable into the

socket on the power supply or rack case. The connector has

a tab that will align with the gap in the socket, so it cannot

be inserted incorrectly. If the power supply does not have

a keyed socket, be sure to orient pin 1 (-12 V) with the

red stripe on the cable.

3. Insert the 10-pin connector into the socket on the back of

the module. The connector has a tab that will align with the

socket for correct orientation.

4. After both ends of the power cable have been securely

attached, you may mount the module in a case and turn on

the power supply.

Installation

The necessary screws are included with the module for mounting

in a Eurorack case. Connect the power cable before mounting.

Depending on the rack case, there may be a series of xed holes

spaced 2 HP apart along the length of the case, or a track that

allows individual threaded plates to slide along the length

of the case. The free-moving threaded plates allow precise

positioning of the module, but each plate should be positioned in

the approximate relation to the mounting holes in your module

before attaching the screws.

Hold the module against the Eurorack rails so that each of the

mounting holes are aligned with a threaded rail or threaded plate.

Attach the screws part way to start, which will allow small

adjustments to the positioning while you get them all aligned.

After the nal position has been established, tighten the

screws down.

902 VOLTAGE

CONTROLLED AMPLIFIER

Legendary Analog VCA Module

for Eurorack

V 1.0

Produktspezifikationen