Behringer PP400 Bedienungsanleitung

Lies die bedienungsanleitung für Behringer PP400 (2 Seiten) kostenlos online; sie gehört zur Kategorie Empfänger. Dieses Handbuch wurde von 46 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 23.5 Bewertungen. Hast du eine Frage zu Behringer PP400 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

MICROPHONO PP400

Welcome to BEHRINGER

Thank you for showing your condence in us by purchasing the BEHRINGER MICROPHONO

PP400, a compact phono preamplier.

Turntables have low-level signals. However, most audio units can only process line-level

signals. Between a turntable and another audio unit (a mixer, an amplier, or a recording

unit), the PP400 acts as an intermediary, as follows:

1. The PP400 equalizes a turntable signal according to RIAA specications.

2. The PP400 amplies the RIAA equalized signal.

3. The PP400 outputs a line-level signal.

◊ Please read the safety instructions that appear at the end of this document.

Connectors and Control Elements

This section illustrates and describes each PP400 connector and control element.

(2)

(1)(5)(3) (4)

Fig. 1: PP400 connectors and control elements

(1) 12 V𝌂 connector:

To connect the power supply unit to the PP400, use the 12 V connector. Connecting the

power supply unit to the mains automatically switches the PP400 on. To disconnect

the unit from the mains, pull out the main cord plug.

(2) ON LED:

As soon as the unit is connected to the mains, the ON LED is illuminated.

(3) INPUT ( and ) connectors: L R

To send a turntable signal to the PP400, you need an RCA audio cable (stereo). Use this

cable to connect:

• the output on the turntable to the (left) INPUT on the PP400 left L

• the output on the turntable to the (right) INPUT on the PP400right R

The PP400 can output a line-level signal via one of the following connectors:

• RCA ((4) OUTPUT L and R)

• ¼” TRS ((5) OUTPUT)

◊ Do not simultaneously use both PP400 OUTPUTs.

(4) OUTPUT ( and ) connectors: L R

To use these RCA connectors, you need an RCA audio cable (stereo). Use this audio

cable to connect:

• the (left) OUTPUT on the PP400 to the input on the amplier, L left

recordingunit, or mixer. (On a mixer, use a CD or TAPE input.)

• the (right) OUTPUT on the PP400 to the input on the amplier, R right

recordingunit, or mixer

(5) OUTPUT connector:

To use this ¼”, TRS (stereo) connector, you need an audio cable. Use the audio cable

to connect the PP400 OUTPUT to an input on the mixer, amplier, or recording unit.

Oneend of this audio cable must include a ¼”, TRS connector. If the input on the mixer,

amplier, or recording unit is:

• stereo, the other end of the audio cable must include a ¼”, TRS connector

• mono, the other end of the audio cable must include 2 TS connectors

(one for each mono input)

SERIAL NUMBER: To register your unit, use the serial number that is located on the bottom

of the PP400.

Setup Example

The following is an example of how to set up the PP400:

OUTPUT

TAPE IN/STREREO

CHANNEL IN

TURNTABLE UB1204-PRO

MICROPHONO PP400

INPUT

Fig 2: PP400 setup example

Produktspezifikationen