BlaknBlu Foxtrot Bedienungsanleitung

Lies die bedienungsanleitung für BlaknBlu Foxtrot (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 28 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 2 Bewertungen. Hast du eine Frage zu BlaknBlu Foxtrot oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

of 14

Foxtrot User Manual

Foxtrot has four identical Voltage Controlled Filter channels. Although they can be linked for

some interesting effects, let’s start by looking at a single filter channel.

1. Basic Operation

Each channel has two mono signal inputs. The two inputs are summed together before being

sent to the filter, with the attenuation of each input being set by the corresponding input trim

pot.

There are two cut off frequency CV inputs per VCF channel, each with its own attenuator control.

The CVs are summed to form the CV controlling the VCF. A CV input of 0V or below corresponds

to the lowest cut-off. If you want to use a bipolar signal to modulate the VCFs (for instance, from

an LFO), just turn up the manual cut off frequency knob.

There are two identical outputs from each filter channel, however, selecting Pan as the Aux CV

input turns the two outputs into a stereo pair, with the pan now controlled by Aux CV.

1.1 CUT OFF FREQUENCY CONTROL

Unsurprisingly, the Cut Off Frequency knob controls the static cut off of the filter. Fully

anticlockwise is the lowest frequency (around 20Hz) and fully clockwise is the highest (around

20kHz depending on the filter model).

Foxtrot User Manual

Firmware v2.1

Signal Inputs

Boost/Overdrive

Filter Link

Filter Model

Signal Input Attenuators

Clipping

Dual/Stereo Outputs

Aux CV Select

Aux CV Input Attenuator

Cut-off CV Input Attenuators

Aux CV Input

Cut-off CV Inputs

Foxtrot Filter

Getting Started

Foxtrot usesa16-pinDoepferstandardpower

cable.Please take care toensure that the cable is

fittedthe correct wayround.

Ifusingthe suppliedpowercable,the plasticlugon

the topofthe cable connectorshouldfit intothe slot

inthe plasticshroudaroundthe PCBconnector.

Asanadditionalcheck,the redwire onthe cable

shouldbe at the endofthe connectormarkedwith

atriangle.

Be sure toturnoffrackpowerbefore starting

installation.

Produktspezifikationen