Caliber Crossover CX 2 R Bedienungsanleitung
Lies die bedienungsanleitung für Caliber Crossover CX 2 R (2 Seiten) kostenlos online; sie gehört zur Kategorie Autoradio. Dieses Handbuch wurde von 31 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 16 Bewertungen. Hast du eine Frage zu Caliber Crossover CX 2 R oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/2
1
1. Low-Pass frequency selector. By using this
selector you can choose the Low-Pass crossover
point (50/80/100/120Hz)
2. High-Pass frequency selector. By using this
selector you can choose the High-Pass crossover
point (80/100/120/140Hz)
3. Level Controls. Since the volume of each output
varies upon speaker efficiency variation and main
amplifier output variation, make adjustments using
these controls.
4. .Phase switch Allows you to change the phase of
your subwoofers from 0° to 180° to help compen-
sate for timing differences between speakers.
5. .Mode switch Allows you to change the subwoof-
er output between stereo and mono, thus facilita-
ting single subwoofer installations.
6. .Input jacks Input from sound source RCA jacks.
7. High level input. Input from sound source’s spea-
ker leads.
8. Low Pass output jacks. Connect RCA cables to
the subwoofer amplifier.
9. .High Pass output jacks Connect RCA cables to
the Mid-High amplifier.
10. .Power connector port B+ : Connect to the (+)
positive terminal of the car battery. Place a fuse
close to the car battery to protect the vehicle.
GND: Connect to a metal part of the car, or nega-
tive (-) terminal of the car battery.
REM: Connect to the remote activating wire of the
radio, or Power antenna wire.
Input
L R
Sub-Woofer
OutL R
High-Pass
OutL R
50 Hz
100 Hz
80 Hz
Mode
Sub-Woofer
Output Level
Min Max
High-Pass
Output Level
Min Max
StereoMono
Phase
ReverseNormal
120 Hz
140 Hz
100 Hz
120 Hz
80 Hz
Power
GND RB+
7 1 2
3
4
5
6 8 9 10
CX2CX2
2-Way 18dB/Oct Electronic Crossover
High Level Input
This diagram shows you a typical configuration. Two
power amplifiers are required. The Low-Pass output
drives the subwoofers amplifier and the High-Pass out-
put drives a second amplifier for your midrange-/twee-
ter system. They could also be full range speakers
except now they are relieved of their deep bass duty
which is carried entirely by the subwoofers.
Full frequency performance is accomplished by the two
groups working together without any overlaps or gaps.
One speaker pair picks up as the other is falling off.The
cut-off frequency for each can be set independently with
the multi-position switches. In most cases they should be
set close to the same frequency to avoid unintentional
peaks or valleys in the system response. This common
cut-off frequency is called the “crossover frequency”.
Connections
Make connections according to the diagram and note
the following:
1. Make all connections securely and avoid stretching
any wires or cables that could pull loose later on.
Never make or break any connection with the power
to your amplifier turned on.
2. Make sure the ground connection attaches to bare
metal that is part of the car’s chassis and not a insu-
lated piece of trim. If you experience excessive noise
during operation, its cause will probably trace back
to a poor ground connection.
3. Make all connections to the CX2 before mounting.
4. Disconnect the car battery to prevent short circuits
while making power connections. Insulate all con-
nections to prevent short circuits.
5. Plug the radio’s pre-out RCA plugs into the CX2’s
input jacks, or connect the radio’s speaker outputs
to the High level input on the Molex connectors and
plug into item 7. Do not use both RCA-input and
High Level input at the same time.
Low-Pass
Audio
Signal
Source
Right
Left
High-Pass
CX2
CX2
Power
Amplifier
Power
Amplifier
2
Produktspezifikationen
| Marke: | Caliber |
| Kategorie: | Autoradio |
| Modell: | Crossover CX 2 R |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Caliber Crossover CX 2 R benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Autoradio Caliber
12 Oktober 2024
7 Oktober 2024
7 Oktober 2024
28 September 2024
11 September 2024
4 September 2024
3 September 2024
30 August 2024
30 August 2024
23 August 2024
Bedienungsanleitung Autoradio
- Opel
- Overmax
- Mystery
- Telefunken
- Carlinkit
- Scott
- Volkswagen
- Telestar
- Kunft
- Skoda
- Trevi
- Alpine
- MB Quart
- Kenwood
- Spectron
Neueste Bedienungsanleitung für -Kategorien-
18 Januar 2026
31 Dezember 2026
2 Dezember 2025
29 November 2025
3 November 2025
3 November 2025
30 Oktober 2025
19 Oktober 2025
16 Oktober 2025
13 Oktober 2025