Canarm KE-08S Bedienungsanleitung

Lies die bedienungsanleitung für Canarm KE-08S (8 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu Canarm KE-08S oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Page 1 of 4

M-KE 26_03_25

GENERAL SAFETY

DIMENSIONS & COMPONENTS

The purpose of this manual is to aid in the proper installation and operation of the Canarm KE Series direct drive radial blade blowers.

These instructions are intended to supplement good general practices and are not intended to overwrite local codes and ordinances.

IT IS THE RESPONSIBILITY OF THE PURCHASER TO ENSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS

EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL.

Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING AND

FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY.

The KE series come prepared from the factory, ready to run when installed and wired. 1.

All electrical work must be done in accordance with all applicable electrical codes by a2.

qualified electrician.

Prior to wiring the unit, ensure the power supply is locked out in the OFF position and that3.

the voltage matches the motor’s requirement, located on the motor’s name plate.

Caution: The unit contains rotating parts, & electrical service. Use appropriate caution when4.

installing and servicing the unit. Install guarding around the intake venturi, or outlet discharge

in applications where it will be not be ducted.

Before starting the unit, ensure all parts are secure & the wheel rotates freely. 5.

Check and tighten where necessary all screws, nuts, bolts, etc. prior to starting the unit. 6.

Some may have loosened during shipping.

NOTE: Check and tighten all hardware after 2 days of initial operation. 7.

Make sure there is no foreign debris in the fan compartment or lodged in the wheel itself. 8.

Blowers should be installed on solid structural foundations. Vibration isolators are9.

recommended. Work should be done under the supervision of licensed mechanical

contractors

Always wear appropriate safety equipment when installing or10.

servicing the unit.

Please follow all applicable national, state/provincial and11.

local codes. All of them will supersede this manual.

Failure to follow the safety instructions in this manual may12.

cause serious injury or death due to electrical shock or high

speed rotating parts.

!"#$

!"#$%&'&%($)((**"($%+"#$*+!($),%"+$*,"#$%,"!$*(-"#$%#$*#"#$%**"""*"($)

!"#%

.&'&+($)()"($**(-"#$%,"($)+"+$*!($),"#$%+"+$*!"#$%!"($*(("#$%#$*%"+$(,.."($%"""."#$*

!"#&&

(-"!$*&'&+"+$*+$*(%"#$%.(("#$%*,"!$*!"($)#$%*,"#$%."($**"($*(#"($%#$*+"($(,(-(-"#$%"""(("#$%

!"#&'

()"($)&'&!"($)!$*(,"#$*(-"($)(#"($%."+$*!"#$**"#$%!$*(-"($**"($)(("($)(-"($)(+"#$(,.$(,,"#$*(#"($%(#"($%(("($*(!

!"#&(

(#"($)&'&*"($*!$*(!"+$*(-"($)(%"+$*(-"#$%**"#$%!$*(("($*."#$*()"+$*(("#$*(,"#$%.$(,!(%"($)(%"+$*()"($%(!

/0123456789:;<=

)*+",-

.*/

01"",2*3">?@A

KE SERIES

DIRECT DRIVE RADIAL

BLADE BLOWERS

OPERATION INSTRUCTIONS AND PARTS MANUAL

PLEASE READ AND SAVE THESE INSTRUCTIONS











































Produktspezifikationen