CDA KC42WH Bedienungsanleitung

Lies die bedienungsanleitung für CDA KC42WH (1 Seiten) kostenlos online; sie gehört zur Kategorie Waschbecken. Dieses Handbuch wurde von 25 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 6 Bewertungen. Hast du eine Frage zu CDA KC42WH oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

KC41 and KC42 Fitting Instructions

FAILURE TO FOLLOWTHESE INSTRUCTIONS CAN LEADTO PREMATURE PRODUCT FAILURE.

The CDA Group Ltd cannot beheld responsible for injuries or losses caused by incorrect use or

installation of thisproduct. Please note thatCDA reserve theright to invalidate the guarantee

supplied with this product following incorrect installation or misuse of the appliance or use in a

commercial environment.

Over Mounting

1.Place the paper template providedcarefully into the correct position on the worktop.

2.Cut along the overmount line until the central section of the worktop comes out.

3.Use clear silicone to seal the cut that has been made; liberally spread the silicone onto the

area of the worktopdirectly adjacent to the hole you have made to the width of the sinkrim

that it will come into contact with.

4.Repeat step3 on the under side of the sink rim itself on the surfacethat will come into

contact with theworktop.

5.Carefully position so that youavoid unnecessary readjustment of the sink at themoment of

contact.

6.Press down firmly and hold in position for at least5 minutes applying an evenpressure.

7.Ensure the sink is fully sealed and the joint is waterproof by squeezing residual silicone out

from along the line of the joint.

8.Do not use the sinkfor at least 24 hours once fitted.

9.After 24 hours check to ensure the seal is waterproof.

Under Mounting

1.Place the paper template providedcarefully into the correct position on the worktop.

2.Cut along theunder mountline until thecentral section of the worktop comes out.

3.Finish the worktop cut out edge to the desired standard.

4.Turn the worktopupside down on a flat, stable surface. Note this will need to be left in

position for24 hours.

5.Spread clear silicone liberally on the glazed surface on the rim of the sinkensuring no areas

are left uncovered.

6.Spread clear silicone liberally on the underside of the worktoptothe corresponding area

where the rim of the sink will be incontact.

7.Press the sink down into the required position firmly for at least 5 minutes applyingeven

pressure. Position a weight on the sink to keep it in place.

8.Ensure the sink is fully sealed and the joint is waterproof by squeezing residual silicone out

from along the line of the joint.

9.Do not use the sinkfor at least 24 hours.

10.3 metal brackets are provided which shouldbe fixed along the front edge and one on each

side; the edge of the bracket overlaps the sink rim and the other edge fixes to the worktop. If

a stone/granite worktop is beingused woodenblocks can be used to affixthe clips to secure

the sink; these should be fixed with an epoxy-type adhesive (follow manufacturers’

instructionsforEpoxy adhesive use).

Produktspezifikationen