Chamberlain 041D8214 Bedienungsanleitung
Chamberlain
Nicht kategorisiert
041D8214
Lies die bedienungsanleitung für Chamberlain 041D8214 (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 32 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 16.5 Bewertungen. Hast du eine Frage zu Chamberlain 041D8214 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/4
End Panel Replacement
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing
ANY service or maintenance.
To prevent damage to the receiver/logic board, DO NOT touch printed
circuit board of replacement receiver/logic board during installation.
ALWAYS wear protective gloves and eye protection when changing
the battery or working around the battery compartment.
A
B
D
C
E
F
WAR NIN G t
AVERTISSEM ENT
WARNING: To av oid SERIOUS
PERSONAL INJURY or DEATH
from electrocution, disconnect
ALL electric a nd ba ttery power
BEFORE performing ANY
maintenance.
AVERTISSEMENT: Pour éviter
des BLESSURES GRAVES ou la
MORT pa r électrocution,
débrancher l’a limenta tion
électrique et de batterie AVANT
TOUTE intervention de
maintenance.
PA
RT
NUMBER:
S ERIAL NUM BER
DATE:
132B2759-5
MAC ADDRESS
IC: 2666A -
FCC ID:
To conne ct to a Wi-Fi Network, visit
wifihelp.cham berlain.c om for more
details . You will nee d your "MyQ Serial
Number " to complete s e tup.
100W Max26W
Max
THE CHAMBERLAIN GROUP INC.
ELMHURST IL, 60126, USA
Ass embled in Mexico
CONTAINS:
FCC ID: COFWMNBM11
IC: 10239A-WMNBM11
Pour vous conne cter à un ré s e au Wi-Fi,
visite z wifihelp.c hambe rlain.com pour
plusde dé tails. Vous aure z be s oin de votre
« Numéro de Série MyQ » pour
complé ter l’installation.
NETWORK SETUP CODE
Red
White
White
Grey
Receiver
Logic
Board
Receiver
Logic
Board
End
Panel
Antenna
wires
End
Panel
Wire
Harnesses
Light Socket Wires
To insert or remove
the wires from the
terminal, push in
the tab with a
screwdriver tip.
Installation
NOTE: The products illustrated in the instructions are for reference. Your
product may look different.
1. Disconnect electrical and battery power (if applicable) to the garage
door opener.
2. Remove the light lens.
• To remove the lens press the release tabs on both sides of lens.
Gently rotate lens back and downward until the lens hinge is in the
fully open position. Lift lens up slightly and remove.
OR
• Press the release tabs on both side of the lens. Squeeze the light
lens clips to remove lens from end panel.
OR
• Remove the light lens by pulling the top sides of the light lens and
rotate the light lens down. Squeeze the light lens clips to remove
lens from end panel.
3. Disconnect the wires ( ). A
4. Remove the end panel.
• Unplug the wire harnesses from the receiver logic board ( ). B
• Remove the receiver logic board ( ).C
• Remove antenna wires from holes in the old end panel ( ).D
• Unplug the wires for the light socket ( ).E
5. A blank label has been provided with your replacement end panel.
Copy the MyQ® Serial Number and all other information from the
original end panel label to the new label. This information is needed
when connecting your garage door opener to the Internet. Apply new
label to replacement end panel ( ).F
6. Discard old end panel.
7. Install the new end panel.
• Connect the wire harnesses to the receiver logic board ( ).B
• Reinstall the receiver logic board ( ).C
• Insert the antenna wires through the holes in the end panel ( ).D
• Connect the wires to the light socket (E ).
• Attach the end panel.
8. Reinsert the wires ( ). A
Door control wires: • white wire into the white terminal.
• white/red wire into the red terminal.
Safety sensor wires: • white wires into the white terminal.
• white/black wires into the grey terminal.
9. Attach the light lens. Make sure the antenna wires are hanging
straight down.
10. Reconnect power to the garage door opener.
11. Test of the safety reverse system. Refer to the owner’s manual.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov
Produktspezifikationen
| Marke: | Chamberlain |
| Kategorie: | Nicht kategorisiert |
| Modell: | 041D8214 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Chamberlain 041D8214 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Chamberlain
13 August 2025
3 Juli 2025
15 Juni 2025
15 Juni 2025
8 Oktober 2024
7 Oktober 2024
2 Oktober 2024
2 Oktober 2024
27 September 2024
19 September 2024
Bedienungsanleitung Nicht kategorisiert
- Davis
- Coolado
- Zodiac
- Kelty
- Bang And Olufsen
- Lupus
- Bimar
- Turmix
- Arzum
- BH Fitness
- IOptron
- Memphis Audio
- Bracketron
- Toolit
- Meris
Neueste Bedienungsanleitung für -Kategorien-
21 Januar 2026
21 Januar 2026
21 Januar 2026
21 Januar 2026
21 Januar 2026
21 Januar 2026
21 Januar 2026
20 Januar 2026
20 Januar 2026
20 Januar 2026