CRUX CGM-01M Bedienungsanleitung
Seiten 2 Engels Rückfahrkamera
Lies die Bedienungsanleitung für CRUX CGM-01M kostenlos online oder lade das PDF herunter. 31 Personen fanden diese Anleitung hilfreich. Frage zu diesem Modell? Stelle eine Frage
CGM-01M
Tailgate Handle Camera with Moving Parking Guide Lines for
CHEVROLET SILVERADO and GMC SIERRA 2014 - 2017
- Replaces the factory tailgate handle and adds a backup camera.
- 170 degree wide view angle for excellent visibility.
- With moving parking guide lines to assist with parking.
- Super CMOS technology provides a sharper picture day and night.
- Maintains the OEM look.
NOTE: Parking Guide Lines will only move when the camera senses that the vehicle is turning while backing up
providing a trajectory for the turn.
PRODUCT FEATURES:
PARTS INCLUDED:
R
INTERFACING SOLUTIONS
Sightline
CAMERAS
1. Tailgate handle camera
2. 26’ extension cable
INSTALLATION INSTRUCTIONS:
1. Start by lowering the tailgate of the truck. Remove the screws that secure the tailgate cover.
2. Aer removing the tailgate cover you will have access to the backside of the factory tailgate handle. Using a
10mm socket, remove the (2) nuts holding the tailgate handle in place. Undo the tailgate latch rods. Li up on
the latch to release the (2) tailgate handle studs and remove the tailgate handle.
3. On the lock cylinder, remove the metal clip that holds the locking mechanism in place. Re-Install the lock cylinder
onto the new tailgate handle.
4. Re-assemble the new tailgate handle into the tailgate in reverse order. Do not put back the tailgate cover
unl aer tesng the camera. Decide whether the parking guide lines will be used or not. See next page for
instrucons on how to turn ON/OFF the parking guide lines.
5. Route the Video and Power cables from the tailgate to the boom of the truck. Route the the camera power
wires to the tail light assembly. Tap the RED wire to the +12V reverse light wire and the BLACK wire to ground.
Connue to route the video cable towards the radio and plug in the video RCA to the back of the aermarket
radio of back up camera interface reverse camera input.
6. Test the camera for funconality then put back the tailgate cover.
Tip: There should be an opening (covered by a rubber boot) between the cabin and the bed of the truck where you
can insert the cables into the cabin area. You can run the video cable under the door sill cover.
Crux Interfacing Solutions • 6860 CanbyAve., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020419
1
Produktspezifikationen
| Marke: | CRUX |
| Kategorie: | Rückfahrkamera |
| Modell: | CGM-01M |
Brauchst du Hilfe?
Wenn Sie Hilfe mit CRUX CGM-01M benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Rückfahrkamera CRUX
CRUX CCH-01S Bedienungsanleitung CRUX CNS-03V Bedienungsanleitung CRUX CFD-03F Bedienungsanleitung CRUX RVCVW-73L Bedienungsanleitung CRUX CDR-03C Bedienungsanleitung CRUX CTY-02T Bedienungsanleitung CRUX CFD-15KM Bedienungsanleitung CRUX CS-PRS3 Bedienungsanleitung
Alle CRUX Rückfahrkamera Bedienungsanleitungen
Beliebt in Rückfahrkamera
CRUX CBM-02T Bedienungsanleitung CRUX RVCCH-75WTC Bedienungsanleitung CRUX CNS-01N Bedienungsanleitung
Bedienungsanleitung Rückfahrkamera
Neueste Bedienungsanleitungen für Rückfahrkamera
Waeco PerfectView CAM55W Bedienungsanleitung Pioneer CA-BC.008-3 Bedienungsanleitung Pioneer CA-BC.004 Bedienungsanleitung Pioneer CA-BC.012-OW Bedienungsanleitung Pioneer CA-BC.007-3 Bedienungsanleitung Dometic PerfectView RVS 764X Bedienungsanleitung Dometic PerfectView CAM 45 NAV Bedienungsanleitung Dometic PerfectView CAM 29BK NAV Bedienungsanleitung Dometic PerfectView CAM 44 NAV Bedienungsanleitung Dometic PerfectView CAM 29S Bedienungsanleitung