Dimplex OSP004 Bedienungsanleitung

Lies die bedienungsanleitung für Dimplex OSP004 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 15 Personen als hilfreich bewertet. Hast du eine Frage zu Dimplex OSP004 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

/ 2 PDF

Installation Instructions

This spacer is suitable for use with the following Inset Fires;

Balmoral, Savena.

Introduction

Installation Place the spacer up againse the back of the re. Ensure that the large holes are to the

open end allowing the pozi-head screw driver though.

Using the 6 screws provided and a pozi-head screw driver, screw the spacer in place

ensuring that the top and side edges of the spacer line up with the top and sides of the

re frame - see diagram

Cleaning For general cleaning use a soft clean duster.

Never use abrasive cleaners

GDC Group Ltd.

Millbrook House,

Grange Drive,

Hedge End,

Southampton,

Hampshire,

SO30 2DF

Tel 0844 879 3588

Fax 0844 879 3583

Website www.valor.co.uk

Republic of Ireland

Tel 01 8424833

c

GDC Group Ltd.

All rights reserved. Material contained in this publication may not be reproduced in whole or part, without prior permission in writing of GDC Group Ltd.

Wall FixingSelect the area where the re is to be xed. mark a point on the centre line of the re

570mm o the oor. Hold the wall bracket against the wall with this mark centred on

the centre hole of the wall bracket, level the wall bracket and mark the 2 outer holes.

Drill the 3 holes with a suitable drill bit and x the bracket to the wall using suitable x-

ings.(the xings provided are only suited for brick/block built walls).

Hang the re on the bracket by the 2 rectangular shaped slots on the rear of the spacer.

570

08/52050/0 Issue 1

Produktspezifikationen