Ditek DTK-2LVLPLV Bedienungsanleitung

Ditek Netzwerkkarte / Adapter DTK-2LVLPLV

Lies die bedienungsanleitung für Ditek DTK-2LVLPLV (1 Seiten) kostenlos online; sie gehört zur Kategorie Netzwerkkarte / Adapter. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 3.9 Sterne aus 2 Bewertungen. Hast du eine Frage zu Ditek DTK-2LVLPLV oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF

Seite 1/1

INSTALLATION

DITEK Corporation

ONE DITEK CENTER

1720 Starkey Road

Largo, FL 33771

INSTALL INSTRUCTIONS

DTK-LVLP SERIES

NOTICE: This SPD should be installed and grounded, by a licensed contractor, per the applicable requirements

of the NEC and the following instructions. These devices are only to be installed on communication loop circuits

which have been isolated from the Public Switched Telephone Network.

APPLICATION

Surge suppression for data circuits, isolated loop circuits, or low voltage telecommunications using a screw

terminal connection.

INSTRUCTIONS:

Caution: Measure all voltages to ensure applied voltage does not exceed the voltage rating of the unit.

Improper installation voids the warranty.

1. Disconnect power to the circuit.

2. The surge protector must be connected in series with the wiring of the equipment to be protected.

3. Securely mount the unit using the double-sided tape (supplied), or two #8 screws (not supplied).

4. Terminate the field wiring to the “IN” side of the surge protector.

5. Terminate the supply wiring from the equipment to the “OUT” side of the surge protector.

6. Allow the surge protector enough reaction time by providing a minimum of 3 feet of wire distance between

the “OUT” side of the surge protector and the equipment being protected.

7. Ground the surge protector using a minimum 14AWG solid or stranded ground wire.

8. If multiple surge protectors are installed on the same circuit, use a common ground source to eliminate the

possibility of a difference in ground potential.

Ground Resistance Rule: Maximum ground resistance is 25 Ohms, 5 Ohms or less is optimum.This cannot

be an assumed value and must be measured to ensure proper grounding.

9. After all connections have been made and no hazards exist, restore power to the circuit.

DITEK TECHNICAL SUPPORT 1-888-472-6100

www.diteksurgeprotection.com

DOC # INT-100051-001

PART NO. 191505 REV. 7

DRAWN BY: BRIAN AYCOCK 10/26/23

APPROVED BY: MIKE MOLINARI 10/26/23

Produktspezifikationen

Marke:	Ditek
Kategorie:	Netzwerkkarte / Adapter
Modell:	DTK-2LVLPLV
Breite:	76 mm
Tiefe:	41 mm
Gewicht:	68 g
Produktfarbe:	Schwarz
Höhe:	41 mm
Material:	ABS
Betriebstemperatur:	-40 - 70 °C
Zertifizierung:	UL497A, UL497B
Anzahl der AC-Ausgänge:	- AC-Ausgänge
AC-Steckertypen:	Terminal
Nominale Eingang Spannung:	24 V
Nominale Stromabgabe:	5 A
Anstieg der Energiemenge:	- J