DNA MIX 4 Bedienungsanleitung
DNA
DJ Ausrüstung
MIX 4
Lies die bedienungsanleitung für DNA MIX 4 (7 Seiten) kostenlos online; sie gehört zur Kategorie DJ Ausrüstung. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 2 Bewertungen. Hast du eine Frage zu DNA MIX 4 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/7

MIX 4 / MIX 4 EQ
User manual
Instrukcja obsługi

ENGLISH
1. Use this balanced XLR jack to connect a microphone to the machine
(applies to channels 1 through 5) The phantom power required for conden-
ser mics can be acvated with switch.
2.PAD
If the [PAD] switch is turned on, set the [LEVEL] 10 knob to “0” (minimum),
and then turn o the switch.
3.HPF
Opening the switch enables a high-pass lter that can aenuate the fre-
quency below 80Hz. When speaking to the microphone, you can open the
switch to minimize the unwanted vibraon and disrupve operaon of the
microphone.
4.The GAIN MIC control determines the channels input gain, both for a mi-
crophone connected via the XLR jack and for other signal sources con-
nected to the 1/4 jack.
5. Use the PAN control to adjust the signal s positon on the stereo ba-
sis.
6. The CHANNEL fader adjusts the volume of the corresponding channel
7. Your machine comes with a 3-band equalizer. the HI control governs
the high frequency range, the MID control can be used to boost/cut the
midrange frequencies, and the LOW control allows you to raise or lower
the gain of the bass range.
8. Use the AUX control to determine the channel volume sent to the
AUX mix bus. When set fully to the le, the channel volume in the AUX mix
is zero.
9. The EFF control adjusts the eects volume for the corresponding
channel.
10.PEAK LED
Lights when the volume of input and/or post-equalizer sound is too high. If
it is lit, turn the [GAIN] 4 knob to the le to lower the volume.

1. Use the TAPE OUT jacks to connect, for example, a tape deck for recording applicaons.
2. The TAPE IN jacks (on stereo RCA) allow for the connecon of play-back devices such as CD,
MIXER, players, etc.
3. These are the two balanced LINE inputs on 1/4 jacks for the le and right sides of the stereo
channels, which can be used in parallel to the microphone inputs.
4. These are the balanced 1/4' jack MAIN OUTPUTS of your machine that can be used to connect,
e.g. a power amplier.
5. The AUX SEND connector provides the monitor signal of your machine, for example, to control a
monitor amplier or acve monitor speaker.
6. Connect the EFF SEND connector to the input of an external eects device.
7. Use the PHONES jack to connect a commercially available pair of headphones.
8. USB INPUT (Use this input for connect your devices).
9. DISPLAY
10. Press this buon to loop the song.
11. Using buon, press one song at a me to lower the volume for more than a few seconds.
12. Using buon, press one song at a me to raise the volume in more than a few seconds.
13. Use buons to control player playback or pause.
Note: the signal of MP3 player is controlled by stereo channel 3 and 4.
Produktspezifikationen
Marke: | DNA |
Kategorie: | DJ Ausrüstung |
Modell: | MIX 4 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit DNA MIX 4 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung DJ Ausrüstung DNA
25 Juli 2025
Bedienungsanleitung DJ Ausrüstung
- Tascam
- Wacom
- Alesis
- CME
- ANT
- Fuzzix
- Apogee
- Motu
- Martin
- MWM
- Arturia
- Pepperdecks
- Eliminator Lighting
- Ibiza Sound
- Victrola
Neueste Bedienungsanleitung für -Kategorien-
24 Juli 2025
23 Juli 2025
23 Juli 2025
22 Juli 2025
22 Juli 2025
19 Juli 2025
17 Juli 2025
17 Juli 2025
17 Juli 2025
16 Juli 2025