Edlund ERS-60 Bedienungsanleitung
Lies die bedienungsanleitung für Edlund ERS-60 (3 Seiten) kostenlos online; sie gehört zur Kategorie Waage. Dieses Handbuch wurde von 37 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 19 Bewertungen. Hast du eine Frage zu Edlund ERS-60 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/3
- 1 - 05/09
Edlund Company, 159 Industrial Parkway, Burlington, VT 05401 802-862-9661 www.edlundco.com
Electronic Receiving Scales
MODEL ERS-60/150/300
Capacity Model ERS-60 (60.0 lbs. X 0.25 ozs., 30.0 Kg X 5 G)
Model ERS-150 (150.0 lbs. X 0.05 lbs., 75.0 Kg X 0.02Kg)
Model ERS-300 (300.0 lbs X 0.1 lbs., 150.0 Kg X 0.05 Kg)
Platform Size Model ERS-60/150 (12" X 12-1/2 )"
Model ERS-300 (19-3/4" X 25-3/4 )"
Overall Size Model ERS-60/150 (12"X 12-1/2 X 2-1/2 )" "
Model ERS-300 (19-3/4 X 25-3/4" " X 4 ")
Power Source 120 VAC, 60 HZ/230 VAC, 50 HZ Output: 12VDC 1000ma
-Not Legal for Trade –
Operating instructions:
The ERS model scale operates on 6xAA batteries, or a 9-volt power supply (part #PS5005). The scale has an
automatic power off feature. (Which can be programmed to 120 sec., 240 sec., 360 sec., 720 sec., or off) If a
battery is used, the scale will shut off after the programmed time if no weighing operation is performed.
To install the batteries, turn the scale display over, open the battery box, install 6xAA batteries (observing
polarity), and close the cover. If the power supply is used, push the power supply tip into the jack orifice,
making sure the two pieces are properly aligned for a tight seal.
Turn on the scale by depressing the "on/off" switch. Scale readout will show all 8's for approximately 5
seconds and then the zero reading. If the scale is overloaded, a series of horizontal lines will be displayed. If
a load is placed on the scale platform, the weight of this load is shown on the scale display in the units in
which the scale is weighing. You can change the weighing mode by pressing the "Hold/Mode" button.
This load can now be "tared out" i.e. shown as zero on the scale display, by depressing the "Tare" button. If
an additional load is then placed on the platform, the weight of this additional load can also be "tared out" by
depressing the "Tare" button. This tare operation can be repeated up to the capacity of the scale.
If the total load is now removed from the platform, the weight of the total load will be shown as a negative
value on the scale display. This negative value can now be removed from the display by depressing the
"Tare" button. Depressing the "on/off' button at any time will turn the scale off.
To use the "Hold" button, place weight on the platform, then press the "Hold" button until the weight starts
blinking. Release the button, and remove the weight from the platform the display. The values will still show
the amount that was on the platform. To remove, just press the "Tare" button and the display returns to zero.
I130
Produktspezifikationen
| Marke: | Edlund |
| Kategorie: | Waage |
| Modell: | ERS-60 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Edlund ERS-60 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Waage Edlund
14 Juli 2025
14 Juli 2025
14 Juli 2025
Bedienungsanleitung Waage
- Esperanza
- Sencor
- Alecto
- Tronic
- Whynter
- Niceboy
- Tefal
- Avery Berkel
- Kela
- Hario
- Robi
- Waves
- Hendi
- AvaWeigh
- Hema
Neueste Bedienungsanleitung für -Kategorien-
21 Januar 2026
18 Januar 2026
17 Januar 2026
16 Januar 2026
16 Januar 2026
15 Januar 2026
14 Januar 2026
2 Januar 2026
1 Januar 2026
30 Dezember 2026