Electro Harmonix Cock Fight Bedienungsanleitung
Electro Harmonix
Nicht kategorisiert
Cock Fight
Lies die bedienungsanleitung für Electro Harmonix Cock Fight (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 31 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 16 Bewertungen. Hast du eine Frage zu Electro Harmonix Cock Fight oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/4
1
Cock Fight
Cocked Talking Wah with Fuzz
Congratulations on your purchase of the Electro-Harmonix , a dual-Cock Fight
filter fuzz box. The contains two different expressive filters: a Cock Fight
traditional wah pedal filter CRY, and a formant filter TALK used for vowel sounds.
The also has a fuzz section that can be added before or after the Cock Fight
filter section, or taken out of the signal path. The BOTTOM and BIAS controls
allow additional tone shaping possibilities. Connect an expression pedal or a
control voltage to the expression input jack for even more sound control.
WARNING: Your Cock Fight comes equipped with an Electro-Harmonix 9.6DC-200BI
power supply (same as used by Boss®
& Ibanez®: 9.6 Volts DC 200mA). The Cock Fight
requires mA at 9VDC with a center negative plug. Using the wrong adapter or a plug 40
with the wrong polarity may damage your Cock Fight and void the warranty.
-QUICK SETUP-
Connect the output plug of the supplied power adapter to the 9V power jack.
Plug your instrument in the INPUT jack; connect your amp to the OUTPUT jack.
Set VOL to about three o’clock, FREQ to max, BOTTOM to min, left switch to
CRY, and right switch to FUZZ OFF. Press the footswitch so that the LED light is
lit. With the effect turned on, you will hear a slight boost in volume as well as a
brighter sound. Adjust the FREQ knob to dial in the cocked wah sound to your
taste. Connect an optional expression pedal to vary the frequency of the filter
continuously as you would with a traditional wah pedal.
- CONTROLS -
VOL Knob – Use this knob to adjust the master output volume.
FREQ Knob – Use to adjust the frequency of the filter selected by the CRY/TALK
toggle switch.
TONE Knob – Use to blend between a darker fuzz and brighter fuzz sound.
DRIVE Knob – Adjust to set the amount of fuzz.
BOTTOM Knob – BOTTOM is a low frequency boost control that is slightly
above unity gain when set fully clockwise. Set fully counterclockwise to remove
the BOTTOM circuit from the signal path. TIP: When used with a bass guitar or
other low frequency sources, the BOTTOM adjustment can help retain the
bottom end typically lost with most wah pedals.
2
CRY/TALK Toggle Switch – The UP position selects the CRY setting. CRY
simulates the type of filter found in a typical wah pedal circuit. The DOWN
position selects the TALK setting. This setting as its name implies produces — —
throaty/vocal vowel sounds.
PRE/FUZZ OFF/POST Toggle Switch – The PRE position places the fuzz
before the filter. Use this position for a vintage Hendrix vibe. FUZZ OFF removes
the fuzz from the signal path. The POST position places the fuzz after the filter
and yields a more modern sound.
BIAS Knob – This knob controls the amount of bias voltage supplied to one of
the transistors in the fuzz circuit. Turn the BIAS knob fully clockwise to supply a
nominal voltage and create a normal fuzz sound. Turn the bias control down
(counterclockwise) to decrease the bias voltage to get the “dying battery” sound.
This type of sound is characterized by a decrease in sustain and by notes that
get choked off you play with less force as .
Footswitch & Status LED – The Footswitch toggles between effect and
buffered bypass. The status LED lights when in effect mode.
INPUT Jack – This ¼” jack is the audio input for the Cock Fight.
OUTPUT Jack – This ¼” jack is the audio output for the Cock Fight.
EXP Jack The expression/CV input controls the frequency knob. The position –
of the FREQ knob sets the maximum sweep range of the expression/CV input.
Expression input jack accepts a TRS expression pedal connector or a Tip-Sleeve
0-5V control voltage input. The expression pedal should ideally use a 10k
potentiometer with linear taper. It must have the wiper connected to TIP and
toe-down connected to RING. Some manufacturers do not conform to ’ pedals
this convention and require a special cable/adaptor to swap RING and TIP.
Suggested Expression Pedals: EHX Expression Pedal, M-Audio® -P, MoogEX ® EP-
2 & EP-3, Roland® -5 or BossEV ® -500L. FV
- CHANGING THE BATTERY -
To change your 9-volt battery, you must remove the 4 screws on the bottom of
the Cock Fight. Once the screws are removed, take off the bottom plate and
change the battery. Please do not We recommend alkaline batteries9V .
touch the circuit board while the bottom plate is off or you risk damaging a
component.
FUZZ ON/OFF Switch –On the PCB there is a small DIP switch that changes
FUZZ OFF to FUZZ THROUGH mode. In FUZZ THROUGH mode the filter section
is bypassed and removed from the signal path. In this mode the knobs FREQ,
BOTTOM and switch CRY/TALK have no effect on the sound.
3
-NOTES AND SPECIFICATION-
• The Cock Fight utilizes a high quality buffered bypass.
• The input impedance is 2M2 .
• The output impedance is 470 .
• The Cock Fights’ current draw is 35mA.
- WARRANTY INFORMATION -
Please register online at http://www.ehx.com/product-registration or complete
and return the enclosed warranty card within 10 days of purchase. Electro-
Harmonix will repair or replace, at its discretion, a product that fails to operate
due to defects in materials or workmanship for a period of one year from date of
purchase. This applies only to original purchasers who have bought their product
from an authorized Electro-Harmonix retailer. Repaired or replaced units will then
be warranted for the unexpired portion of the original warranty term.
If you should need to return your unit for service within the warranty period,
please contact the appropriate office listed below. Customers outside the regions
listed below, please contact EHX Customer Service for information on warranty
repairs at info@ehx.com or +1- - -8300. USA and Canadian customers: 718 937
please obtain a (RA#) from EHX Customer Return Authorization Number
Service before returning your product. Include with your returned unit a written
description of the problem as well as your name, address, telephone number, e-
mail address, RA# and a copy of your receipt clearly showing the purchase date.
United States & Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
47-50 33RD STREET
LONG ISLAND CITY, NY 11101
Tel: 718- - 937 8300
Email: info@ehx.com
Europe
JOHN WILLIAMS
ELECTRO-HARMONIX UK
13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ
UNITED KINGDOM
Tel: +44 179 247 3258
Email: electroharmonixuk@virginmedia.com
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at info@ehx.com
Produktspezifikationen
| Marke: | Electro Harmonix |
| Kategorie: | Nicht kategorisiert |
| Modell: | Cock Fight |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Electro Harmonix Cock Fight benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Electro Harmonix
5 September 2024
5 September 2024
5 September 2024
4 September 2024
4 September 2024
3 September 2024
Electro Harmonix Germanium 4 Big Muff Pi Bedienungsanleitung
3 September 2024
3 September 2024
Electro Harmonix Deluxe Memory Man 550-TT Bedienungsanleitung
3 September 2024
28 August 2024
Bedienungsanleitung Nicht kategorisiert
- Flaem
- Cotech
- Metz Connect
- MXL
- ResMed
- Chefman
- TUSA
- Tiger
- Bright Spark
- Pyle Pro
- Gretsch
- Milesight
- Studiologic
- VCM
- Sensiplast
Neueste Bedienungsanleitung für -Kategorien-
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025