Epson Expression Home XP-400 Bedienungsanleitung

Lies die bedienungsanleitung für Epson Expression Home XP-400 (4 Seiten) kostenlos online; sie gehört zur Kategorie Drucker. Dieses Handbuch wurde von 24 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 5 Bewertungen. Hast du eine Frage zu Epson Expression Home XP-400 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

5Load paper against the right edge guide and behind the

tab line on the left edge guide, with the printable side

faceup.

8½ × 11 inch

(216 × 279 mm)

4 × 6 inch

(102 × 152 mm)

Note: Don’t load the paper sideways; always load it short

edge first.

6Slide the edge guide over, against the left edge of

the paper.

7Flip the feeder guard back.

Read these instructions before using your product.

1

Unpack

Caution: Do not open ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials, including from inside the printer.

2

Turn on and adjust

1 Raise the paper support, then connect the power cord to

the back of the printer and to an electrical outlet.

Caution: Do not connect to your computer yet.

2Raise the control panel, then press thepower button.

Note: If you want to lower the control panel, squeeze the release

bar underneath.

Caution: Do not lower the control panel without first squeezing the

release bar underneath or you may damage the product.

3 To select English as your language, press OK.

If you want to change the language, press or to select it, then

press OK.

Note: You can change the language later using the product’s

control panel. For more information, see the online User’s Guide.

3

Install ink cartridges

Note: Don’t load paper yet.

1 Lift up the scanner unit, and wait until the ink cartridge

holder stops moving.

2 Shake the ink cartridges gently 4 or 5 times, then

unpack them.

3Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

4 Insert the cartridges in the holder for each color, and press

each cartridge down until it clicks.

5Lower the scanner unit.

6Press OK to prime the ink delivery system. Priming takes

about 4 minutes.

Note: The cartridges included with the printer are designed for

printer setup and not for resale. After some ink is used for priming,

the rest is available for printing.

Caution: Don’t turn off the printer while it is priming or you’ll

waste ink.

4

Load paper

1Flip the feeder guard forward.

2 Raise the paper support, if necessary. Then pull up the

extension and tilt it back slightly.

3Pull out the output tray, then raise the paper stopper.

4Slide the edge guide to the left.

XP-400 Small-in-One

™

Printer

Start Here

Produktspezifikationen