Escort Passport GT1 Bedienungsanleitung
Escort
Nicht kategorisiert
Passport GT1
Lies die bedienungsanleitung für Escort Passport GT1 (17 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 3.9 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu Escort Passport GT1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/17
V E H I C L E P E R F O R M A N C E C O M P U T E R
O w n e r ’ s M a n u a l
GT1
The manufacturer is not responsible for any accidents,
property damage, or injuries that occur while using
the Performance Computer.
Like your car’s speedometer, this device is no more than
a measuring instrument, a tool that can be used to
measure vehicle performance. Obey all traffic laws on
the street. Drive responsibly, and use common sense.
ROLLOVER WARNING
This device measures G-Forces, but it does not change
the laws of physics. Under certain circumstances,
almost any vehicle can roll over, causing serious injury
or death. Taller vehicles such as SUVs, trucks, and vans
are more likely to roll than conventional cars, so even
more care needs to be taken with those vehicles.
No electronic device can take the place of the driver’s
judgment.
One-button Operation 3
Quick Start Guide 4-5
Remote Control Cord 6
Installation 6-7
G-Meter Operation 8-12
How it works 13
Specifications 13
Performing Timed Runs 14-17
Measuring Horsepower 18-19
Using the Setup Mode 20-26
Accessories 27
Troubleshooting 28
Warranty 30
Service 31
One-button operation
TIMED RUN OPERATION
Stop car,
press TIMED RUN button,
then start anytime.
REVIEW TIMED RESULTS
Press UP or DOWN buttons
to review data from
last timed run.
G-METER CALIBRATION
Install unit on windshield,
park on level ground,
press CALIBRATE button.
IndexWARNING
Ready
Start Anytime
32
G-METER OPERATION
Press and release G-METER button
to display G-Forces. Press again to
choose alternate G-Meter displays.
To enter Setup Mode, hold this button
Please read the entire manual to learn details of the
many capabilities of your new Performance Computer.
This page provides only a basic overview of the instal-
lation, features, and capabilities.
INSTALLATION
1) Plug into lighter socket
Plug the cord into the Performance Computer, and into
your car’s lighter socket. The Performance Computer is
always “On,” there is no on-off switch.
(If your car’s lighter socket is always powered,
unplug the Performance Computer when not in use to
avoid discharging your car’s battery.)
2) Attach to windshield in center of car
Mount the Performance Computer centered between
the driver and passenger with the suction cup mount.
Make sure the unit is mounted squarely in the car. Do
not mount the unit so it is angled toward the driver.
Pivot the unit on the bracket until it is approxi-
mately level (it is not necessary to be perfectly level).
3) Park on a level surface, then press
and release the CALIBRATE button
Each time you remount the unit, you must calibrate
the G-Meter. (The calibration is stored in memory even
if the unit is unplugged, so you don’t need to calibrate
again unless you reposition or reinstall the unit.)
Quick Start Guide
G-METER BUTTON
Press and release to select different
displays of G-Forces and other data
Except when performing timed runs, the unit is nor-
mally in the “G-METER” mode, where it can display
the acceleration, braking, and cornering G-forces of
your car. Press and release to select different G-Meter
displays. A good initial choice is G-Meter Option 1, a
Bar Graph that shows acceleration and braking forces
on the top line, and cornering forces on the bottom line.
SETUP MODE
Hold the G-METER button
to enter Set-Up mode
Power-on LED
Ready
Start Anytime
54
UP AND DOWN BUTTONS
Press to review timed runs
The most recent run is saved in memory. Press the UP
and DOWN buttons whenever you want to review this
run.
CALIBRATE BUTTON
Press and release to calibrate G-Meter
BRIGHTNESS ADJUSTMENT
Hold the CALIBRATE BUTTON to adjust
the brightness of the display
TIMED RUN BUTTON
Press and release to start a timed run
Your car must be stopped before you can perform a
timed run (0-to-60, quarter mile, etc.).
1) Press and release the button
2) Wait a few seconds until the display
shows “Run READY, Start anytime”
3) Accelerate whenever you are ready.
During your run, the unit automatically records and
saves complete run data. The yellow LED lights when
the unit is in the timed run mode and also when you
are reviewing timed runs.
Produktspezifikationen
| Marke: | Escort |
| Kategorie: | Nicht kategorisiert |
| Modell: | Passport GT1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Escort Passport GT1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Escort
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
Bedienungsanleitung Nicht kategorisiert
- Hayward
- ESUN
- J.P. Instruments
- Iadea
- Musser
- Emmaljunga
- Spelsberg
- Techly
- Mr. Beams
- Antelope
- Audiovox
- Rolly Toys
- Vistus
- Owon
- ISpring
Neueste Bedienungsanleitung für -Kategorien-
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025
15 Juli 2025