Escort Passport GT2 Bedienungsanleitung
Escort
Nicht kategorisiert
Passport GT2
Lies die bedienungsanleitung für Escort Passport GT2 (19 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 2 Bewertungen. Hast du eine Frage zu Escort Passport GT2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/19
V E H I C L E P E R F O R M A N C E C O M P U T E R
O w n e r ’ s M a n u a l
GT2
The manufacturer is not responsible for any accidents,
property damage, or injuries that occur while using
the Performance Computer.
Like your car’s speedometer, this device is no more than
a measuring instrument, a tool that can be used to
measure vehicle performance. Obey all traffic laws on
the street. Drive responsibly, and use common sense.
ROLLOVER WARNING
This device measures G-Forces, but it does not change
the laws of physics. Under certain circumstances,
almost any vehicle can roll over, causing serious injury
or death. Taller vehicles such as SUVs, trucks, and vans
are more likely to roll than conventional cars, so even
more care needs to be taken with those vehicles.
No electronic device can take the place of the driver’s
judgment.
One-button Operation 3
Quick Start Guide 4-5
Remote Control Cord 6
Installation 6-7
How it works 8
Specifications 8
G-Meter Operation 9-15
Performing Timed Runs 16-19
Measuring Horsepower 20-23
Using the Setup Mode 24-30
Optional Accessories 31
Troubleshooting 32
Warranty 34
Service 35
One-button operation
G-METER OPERATION
Press and release G-METER button
to display G-Forces. Press again to
choose alternate G-Meter displays.
3
IndexWARNING
2
To enter Setup Mode, hold this button
To adjust display brightness, hold this button
G-METER CALIBRATION
Install unit on windshield,
park on level ground, then press
and release CALIBRATE button.
REVIEW TIMED RESULTS
Press UP or DOWN buttons
to review data from
last ten timed runs.
TIMED RUN OPERATION
Stop car,
press TIMED RUN button,
then start anytime.
Please read the entire manual to learn details of the
many capabilities of your new Performance Computer.
This page provides only a basic overview of the instal-
lation, features, and capabilities.
INSTALLATION
1) Plug into lighter socket
Plug the cord into the Performance Computer, and into
your car’s lighter socket. The Performance Computer is
always “On,” there is no on-off switch.
(If your car’s lighter socket is always powered,
unplug the Performance Computer when not in use to
avoid discharging your car’s battery.)
2) Attach to windshield in center of car
Mount the Performance Computer centered between
the driver and passenger with the suction cup mount.
Make sure the unit is mounted squarely in the car. Do
not mount the unit so it is angled toward the driver.
Pivot the unit on the bracket until it is approxi-
mately level (it is not necessary to be perfectly level).
3) Park on a level surface, then press
and release the CALIBRATE button
Each time you remount the unit, you must calibrate
the G-Meter. (The calibration is stored in memory even
if the unit is unplugged, so you don’t need to calibrate
again unless you reposition or reinstall the unit.)
Quick Start Guide
G-METER BUTTON
Press and release to select different
displays of G-Forces and other data
Except when performing timed runs, the unit is nor-
mally in the “G-METER” mode, where it can display
the acceleration, braking, and cornering G-forces of
your car. Press and release to select different G-Meter
displays. A good initial choice is G-Meter Option 1, a
Bar Graph that shows acceleration and braking forces
on the top line, and cornering forces on the bottom line.
SETUP MODE
Hold the G-METER button
to enter Set-Up mode
Power-on LED
54
TIMED RUN BUTTON
Press and release to start a timed run
Your car must be stopped before you can perform a
timed run (0-to-60, quarter mile, etc.).
1) Press and release the button
2) Wait a few seconds until the display
shows “Run READY, Start anytime”
3) Accelerate whenever you are ready.
During your run, the unit automatically records and
saves complete run data. The yellow LED lights when
the unit is in the timed run mode and also when you
are reviewing timed runs.
UP AND DOWN BUTTONS
Press to review timed runs
The 10 most recent runs are saved in memory. Press
the UP and DOWN buttons whenever you want to re-
view these runs.
CALIBRATE BUTTON
Press and release to calibrate G-Meter
BRIGHTNESS ADJUSTMENT
Hold the CALIBRATE BUTTON to adjust
the brightness of the display
Produktspezifikationen
| Marke: | Escort |
| Kategorie: | Nicht kategorisiert |
| Modell: | Passport GT2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Escort Passport GT2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Escort
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
10 Juli 2025
Bedienungsanleitung Nicht kategorisiert
- Carcomm
- Yoshino
- Club 3D
- JBL
- Wingart
- AV Tool
- Xplora
- Liebherr
- Thermador
- MIPRO
- ToughTested
- Nicols
- Faber
- A-Designs
- Tacklife
Neueste Bedienungsanleitung für -Kategorien-
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025
11 Juli 2025