Eureka Tundern Cove 4 Bedienungsanleitung

Lies die bedienungsanleitung für Eureka Tundern Cove 4 (5 Seiten) kostenlos online; sie gehört zur Kategorie Zelt. Dieses Handbuch wurde von 68 Personen als hilfreich bewertet und erhielt im Schnitt 4.2 Sterne aus 34.5 Bewertungen. Hast du eine Frage zu Eureka Tundern Cove 4 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1.Unroll your tent and separate the tent from the fly. Assem-

ble the frame poles being sure all connections are com-

plete.

2.Spread out the tent in desired site location. Stake corner

facing into wind in windy conditions.

3.Insert tent corner pin into the end of one of the long tent

poles. Follow up tent seam, locate first clip and attach to

pole. Move to the opposite corner repeating the process

4.Repeat step 3 with the second long frame pole.

5.Attach remaining clips to frame.

6.Tent can now be staked in location.

7.Spread the fly sheet over the tent positioning the vestibule

over the front tent door. Front side will have yellow web-

bing at corner of the tent, the front corners will have two

pins, one for main frame and one for vestibule pole.

8.Feed the vestibule pole through the vestibule pole sleeve

always pushing, never pulling.

9.Take one end of the vestibule pole and insert a pin into the

pole end. The pin will be located on the corner ring of the

tent.

10.Repeat step 9 with the other end of the pole. During this

step the vestibule pole will flex into a hoop.

11.Attach all four fly sheet corners, with the hooks provided,

to the four tent corner rings.

12.Stretch out the vestibule and stake out using the two fabric

loops

13.On each side and the back of the tent are positions sup-

plied to pull out the fly sheet and stake. The back has a rear

single point vestibule.

14.On the underside of the tent fly sheet locate the Velcro fas-

teners and wrap around the tent poles.

15.If required, for windy conditions you can use the pre-

rigged guylines to stake out for more stability.

ASSEMBLY INSTRUCTIONS for Tundern Cove 4

Important

• Please set up your tent prior to your first trip to ensure you

are familiar with set up and the tent is in proper condition.

• Always choose a site with good drainage. Inspect the site and

remove any sharp or protruding objects that could damage

the tent floor.

• Although major seams are taped we recommend seam seal-

ing guy out locations due to stitching through tape, and any

other seams where taping may not have been possible

1.The suns UV rays can be harmful even with technical ad-

vances in fabrics. Prolonged exposure could result in fading

and possibly fabric disintegration. When choosing a site try

to pitch the tent in a shaded area. Do not leave a tent up

longer than necessary.

2.Fuels can damage tents as can DEET found in many insect

repellents.

3.All major seams are factory taped. Over time seams could

experience delamination. Simply clean the seam and apply

seam sealer that can be purchased at most outdoor stores.

4.Avoid storing your tent in a hot location.

5.Please be sure to store your tent dry. Mildew can occur on

waterproof coatings if stored when wet.

TIPS

SET UP

Produktspezifikationen