Extech VFM200 Bedienungsanleitung
Lies die bedienungsanleitung für Extech VFM200 (5 Seiten) kostenlos online; sie gehört zur Kategorie Multitool. Dieses Handbuch wurde von 18 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 9.5 Bewertungen. Hast du eine Frage zu Extech VFM200 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/5
UserManual
Formaldehyde(HCHOorCH20) and Total
VolatileOrganicCompounds(TVOC)Tester
ModelVFM200
AdditionalUserManualTranslationsavailable at www.extech.com
2VFM200‐en‐GB_V1.212/16
1
6
5
7
2
3
4
8
Introduction
Thank you for Theselectingthe Extech InstrumentsModelVFM200. VFM200measuresHCHO
(formaldehyde)andTVOC(TotalVolatileOrganicCompounds).
Potentialsources paints,forTVOCsinclude finishes,adhesives,cigarettesmoke,pesticides,
personalcare wallproducts,carexhaust, furnishings,new coverings,householdcleansers,and
cookingfuels. Acetone, Formaldehyde,Chemicals include: EthyleneGlycol, Xylene, 1,3‐butadiene,
Tetrachloroethene,HydrogenSulfide,Ammonia,Toluene,Benzene,MethyleneChloride,
Perchloroethylene,andMTBE.
This calibrateddeviceisshipped testedfully and and,withproperuse,willprovideyearsofreliable
service. forPleasevisitour website (www.extech.com) tocheck thelatestversionofthisUser
Guide,ProductUpdates,andCustomer Support.
Features
Fuel Cell FormaldehydeSensorTechnology
High accuracy measurements
Backlit LCD display
Real‐ time display of HCHO (formaldehyde)concentrationinair
Real‐time display of TVOC (TotalVolatileOrganicCompounds)concentrationinair
Two unit selections (PPM, mg/m³)
Audio‐ visual High and Low Alarms for HCHO
Autopoweroff
Description
METERDESCRIPTION
1. HCHOsensor(front)
2. ACAdaptorjack(underflap)
3. DownarrowandAlarmSetupbutton
4. Battery compartment(rear)
5. ON‐OFFbutton(alsousedinAlarmSetup)
6. UparrowandUNITselectionbutton
7. BacklitDisplay
8. TVOCsensor(rear)
3VFM200‐en‐GB_V1.212/16
mg/m
mg/m
3
3
1
2
3
4
5
6
7
LCDDISPLAY
1. HCHOreading
2. TVOCreading
3. Selectableunits of measure
4. AlarmBeepersymbol
5. AutoPowerOFFreminder
6. RechargeableBatterystatus
7. HighandLow Alarm symbols
Operation
POWERTHEMETER
Pressthe button to turn on the meter. The battery symbol informs the user as to the battery
strength.Connectthe recharge the thebatterychargerto battery. Longpress buttonto
poweroff.TheLCDwillcountdown: 3, 2, 1, then OFF before switching off.
AUTOPOWEROFF
The offmeterwillswitch after30minutesofinactivity.Pressany preventfunctionbuttonto the
meterfrompoweringoff;the auto timer power off will be then be reset. The APO display
symbolreminds thattheuser AutoPowerOFFisalwaysactive.
GERNERALUSE
All LCD display lines will switch ON when power is applied to the meter. The bottom TVOC
displaywillcountdownfrom10secondsorfrom90seconds(dependingonthe
environment)tozero.Whencountdownis iscompletethemeter readyforuse.
In normal mode, the top display indicates the HCHO concentration in PPM or mg/m³. The
bottom display indicatestheTVOCconcentrationinPPMor mg/m³.
Use the UNIT button to switch units between PPM andmg/m³.
With the meter on, ‐if the measured HCHO concentration exceeds the high or low user
programmableAlarmthresholds,theLEDdisplaywillflashredincolorandtheaudible
beeperwillsound(unlessithasbeen disabled withthe SET/▼button).PressSET/▼ to
silencethe thealarm orbeeper(whenit is sounding) to disable beeperentirely.When
disabled,the displayed beepersymbolisswitchedoff.
ALARMSETUP(HCHOonly)
LowAlarmSetup
1. the the LongpressSET/▼ buttontoenter setupmode.
2. the LCD the Thelow iconalarm willdisplayand willshow lowalarmthreshold.
3. the the Use ▲and▼ buttonstoadjust lowalarmthreshold.
4. the Press button to go to the high alarm setup screen.
HighAlarmSetup
1. the the Use ▲and▼ buttonstoadjust highalarmthreshold.
2. the the Press buttonto toreturn normalmeasurementmode.
Produktspezifikationen
| Marke: | Extech |
| Kategorie: | Multitool |
| Modell: | VFM200 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Extech VFM200 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Multitool Extech
23 Juli 2024
Bedienungsanleitung Multitool
- Meec Tools
- Topcraft
- G-Technology
- CMT Orange Tools
- Renovator
- Kress
- Silverline
- Rocktrail
- Fein
- Dremel
- Black And Decker
- Cocraft
- Powerfix
- Stiga
- Trotec
Neueste Bedienungsanleitung für -Kategorien-
15 Oktober 2024
14 Oktober 2024
9 Oktober 2024
8 Oktober 2024
4 Oktober 2024
29 September 2024
21 September 2024
12 September 2024
11 September 2024
9 September 2024