Extron Cable Cubby 1252 Bedienungsanleitung

Lies die bedienungsanleitung für Extron Cable Cubby 1252 (25 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 39 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 3 Bewertungen. Hast du eine Frage zu Extron Cable Cubby 1252 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1

Cable Cubby 1252 MS Lid Tray Kit •

Installation Guide

This guide provides instructions for an experienced technician to install the Extron

Cable Cubby 1252 MS Lid Tray Kit onto the Cable Cubby 1252 MS enclosure. The lid tray

offers a clean nished edge for the lid insert material.

The surface-matching Cable Cubby 1252 MS is a furniture-mounted enclosure for cable access,

connections, and AC power. The Cable Cubby 1252 MS provides the freedom to either match the surface of

the table or use a unique lid design that complements your décor. Unused cables can be stored out of the way while remaining

connected to the presentation system.

Planning

Check all parts and equipment before installation

Ensure that all parts are present in the kit.

Ensure that necessary tools (Phillip’s head screwdriver and, potentially, shims or putty) are available for the installation.

Kit Contents

PartQuantityPartQuantity

Lid tray

1#4-40 at head lid tray screws

4

#6 at head lid insert

wood screws

4

Preparing the Cable Cubby 1252 MS and Table

See the for the steps necessary to prepare the Cable Cubby enclosure for installation of Cable Cubby 1252 MS Installation Guide

the lid. The lid tray is to be installed in place of the fabricated lid in that guide.

NOTE:If you are surface-matching the table for the lid insert material:

• See “Cutting the Lid Insert Material,” below.

• Make the cut as accurate as possible, the cutout piece can be used for the lid insert to be attached to the lid tray.

Cutting the Lid Insert Material

8.375"

(212.7 mm)

4.25"

0.70" MA

X

(107.9 mm)

(17.75 mm)

(Varying

thickness)

ers

(107

.

9

(

3.0 mm

)

Radius

C

orn

0.12"

1. Cut a piece of lid insert material to the dimensions shown at

right, as accurately as possible.

Produktspezifikationen