Extron MAAP 100 Bedienungsanleitung

Lies die bedienungsanleitung für Extron MAAP 100 (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 25 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 3 Bewertungen. Hast du eine Frage zu Extron MAAP 100 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Extron AAP 100 and MAAP 100 Installation Guide

The following procedure is for mounting the AAP 100 and MAAP 100 panels

on hard surfaces (plywood, hardwood, etc.). For soft surfaces (particle

board, drywall, etc.), additional hardware such as anchors may be required

(not provided).

1.Make a copy of the appropriate full size rough-in template. Cut out the

center portion of the template up to the dashed guidelines.

CFor accurate sizing, copy the template at exactly 100%.

2.Place the template in the desired location and mark the guidelines for

the opening on the surface.

3.Carefully cut away the material inside the guidelines. Check the

opening size by placing the panel against the opening.

4.Cable the AAP(s)/MAAP(s) and install them on the panel.

5.Place the panel against the surface and mark the locations of the two

wall mounting holes on the surface.

6.Remove the panel and drill 1/4" deep pilot holes (half the width of the

shaft of the screw) at the marked locations. Replace the panel.

7.Use two 1/2" (1.3 cm) long, #6 flat headed wood screws (provided) to

fasten the panel directly onto the surface. Hand tighten the screws.

Product Dimensions

68-837-01 Rev. B

08 08

1.750

2 x 0.875

0.000

0.250

4.250

4.500

0.000

0.100

0.000

0.250

3.000

3.250

1.750

2 x 0.875

0.000

0.100

The dashed line indicates the

recommended cut-out area

for the installation surface.

1.5" H x 2.25" W

(3.8 cm H x 5.7 cm W)

The solid, outer line

represents the outside

edge of the panel.

1.75

"

H x 3.25

"

W

(4.45 cm H x 8.25 cm W)

Template for

the MAAP 100

Installation Templates

© 2008 Extron Electronics. All rights reserved.

Extron USA - West

Headquarters

+6800.633.987

Insideanad U / CSAa Only

+1.7104.491.150

+1.7174.491.151FAX

Extron USA - East

+800.633.9876

Insideanad UA / CSa Only

+1.919.863.1794

+1.919.863.1797FAX

Extron Europe

+800.3987.6673

Insideurop Ee Only

+31.303.4.45304

+31.3 3.4.453050FAX

Extron Asia

+6800.7339.876

Inside Aa siOnly

+65.6383.4400

+65.6383.4664FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566FAX

Extron Dubai

+971.4.2991800

+971.4.2991880FAX

The dashed line indicates the

recommended cut-out area

for the installation surface.

1.5" H x 3.5" W

(3.8 cm H x 8.9 cm W)

The solid, outer line

represents the outside

edge of the panel.

1.75" H x 4.5" W

(4.45 cm H x 11.4 cm W)

Template for

the AAP 100

Produktspezifikationen