Extron TLP 710TV Bedienungsanleitung

Lies die bedienungsanleitung für Extron TLP 710TV (2 Seiten) kostenlos online; sie gehört zur Kategorie Fernbedienung. Dieses Handbuch wurde von 51 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 3 Bewertungen. Hast du eine Frage zu Extron TLP 710TV oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Installation Guide — BB 700M

The Extron

®

BB 700M is a wall box for wall-mounting Extron TLP 700MV TouchLink

™

panels. It provides access for A/V signals

and 12 VDC power. A trim ring (TR 700M), is available as an optional accessory.

This Installation Guide provides instructions for mounting the BB 700M in a new installation or retrofitting an existing drywall.

Retrofit an Existing Installation (After the Drywall is in Place)

1. Remove the screws holding the top and bottom endplates of the BB 700M

to the U-plate (sides and back). Separate and remove the endplates.

2. Use the trim ring or the back face of the U-plate to mark the position

where the hole will be cut.

N

The hole is 9.55 inches (24.26 cm) wide x 6.55 inches (16.64 cm) high.

T

Use a level and temporarily secure the trim ring to the wall to ensure the

position of the hole is marked as accurately as possible. Once the hole

is marked, remove the trim ring to avoid damaging it while cutting the

drywall.

3.

Use a drywall saw to cut out a hole where the TLP 700MV will be

installed. Cut the lines that you marked in step .on2

4. Run the cable conduits through the wall to the top of the hole. Leave

some slack to connect the conduit to the BB 700M and the cables to the

TLP 700MV.

5. If necessary, clear the cables and conduits from the space behind the

hole so that it is clear for the U-plate to be inserted.

6. Insert the U-plate into the hole (see figure 1).

N

The tabs of the wall box sit on the outer face of the drywall.

7. Pull back the cables that were cleared out of the way in step .5

8. Secure one or more conduits to one of the endplates. There are

punch-outs in the top and bottom endplates (see figure 2).

9. Slide the endplates into the gap between the back of the U-plate and

the top flanges on the side of the U-plate. (see inset in figure 2)The

endplate must pass the drywall so that it can be pushed up behind it.

10.

Snap the four plastic ribs from the TR 700M trim ring so that the trim

ring fits over the metal tabs of the BB

700M (see inset in figure 3).

11. Secure the trim ring to the wall with

four screws through the holes in the

frame (two on each side).

12.

Finish installing the TLP 700MV as

described in steps to 811 on the next

page (and see figure 3).

8

9

Figure 2

6

Tabs (4)

Figure 1

Faceplate Snaps to Unit

(4 plcs ea side)

Tighten Screws to

Rotate Locking Arms

Trim Ring

Break

Off Rib

Screws (4)

Figure 3

Produktspezifikationen