Fantini Cosmi P30A Bedienungsanleitung

Lies die bedienungsanleitung für Fantini Cosmi P30A (2 Seiten) kostenlos online; sie gehört zur Kategorie Gasdetektor. Dieses Handbuch wurde von 11 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 6 Bewertungen. Hast du eine Frage zu Fantini Cosmi P30A oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

INSTALLATION

P30A GENERAL CONTROL PANEL INSTALLATION

Screw the fixing stay-bar and release the control panel

socket . Remove the socket by pulling with a

screwdriver on the latching tabs.

Fix the terminal-holders of the wall detector (according

to the fixing systems shown hereby) in a dry not

dripping place.

SENSORS DETECTORS

They shuold be fixed on a wall at an approximate

distance of 2 meters form the gas device in such a

position as to allow natural air circulation:

-S71 for specific ligth gases (natural gas, city gas) has

to be fixed at an high level approximately 30/40 cm

from the ceiling.

-S72 for heavy gases (cylinder liquid gas LGP) has to

be fixed to a low level approximately 30/40 cm above

the floor.

Avoid installing sensors:

-behind barriers that can prevent the natural air

circulation in the area

-close to air conditiong units (minimum distance 2

meters)

-close to fumes, steams or other exhalation sources

Remove the cover four front retaining screws, fix the

base to the wall, using for the cables entrance the

special press-.cables.

GAS DETECTOR VALVE

Choose the gas interception valve among one of the

serie Z-EV, generally closed with quick on and off

realease switch, class A with approval (or

corresponding models) according to diameter and gas

pipe type.

Install the valve in the most suitable part of the plant

downstream the counter or at the exit of the

accumulation tanks.

ACOUSTIC/VISUAL EXTERNAL SIGNALLER

Use the self-fed type most suitable with your kind of

plant, place it in an easely visibles place.

CONNECTIONS WITH POSSIBLE FIRE ALARM

CONTROL SYSTEM AND/OR ANTI-INTRUSION

DEVICE.

The voltage free terminal exchange contact available

for the external acoustic/visual signaller can in

alternative be used for connections with alredy exiting

central alarm panels.

CONTROL PANEL

CENTRAL CONTROL CONSOLE

Visual indicator: normally switched off, flashes in case

of alarm. It can be switched off only through the reset

button.

Operating indicator: always switched on.

Alarm sensors indicators: generally switched off they

switch on when the connected sensor send an alarm

signal. They switch off when the gas concentration

goes back to the allowed levels.

Test switcher to verify the device except for the

sensors.

Switch for external siren silencing: it allows to switch

off the siren even during an alarm situation.

Reset switch to stop the alarm after the cause has

been removed.

Operation delay: unique for all sensors, regulates the

delay once that a warning situation has been detected

by all sensors and it has activated the general alarm.

Acoustic signaller: positioned inside the central

control panel operates in case of alarm. It can be

switched off only through the reset switch.

SENSOR

Operating indicator: always switched on.

Fault indicator sensor

Alarm indicator: generally switched off, it operates

and remains on for all the time in which the gas

concentration remains above the established level.

A

B

C

D

E

F

G

H

I

L

M

C

B

I

L

M

F

H

G

A

SENSORS

CENTRAL

(INTERNALS)

93

91

110

P30A CENTRAL CONTROL PANEL:

OVERALL DIMENSIONS

WALL FIXING

BACK-CONTROL CONSOLE FIXING

EXTRACTION SOCKET

SENSORS: OVERALL DIMENSIONS

Produktspezifikationen