Fisher & Paykel ADDD24SPX Bedienungsanleitung

Lies die bedienungsanleitung für Fisher & Paykel ADDD24SPX (1 Seiten) kostenlos online; sie gehört zur Kategorie Spülmaschine. Dieses Handbuch wurde von 35 Personen als hilfreich bewertet und erhielt im Schnitt 3.5 Sterne aus 18 Bewertungen. Hast du eine Frage zu Fisher & Paykel ADDD24SPX oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

INSTALLATION GUIDE

Accessory door panels

DOOR PANEL INSTALLATION

431158A 10.22 US CA

SAFETY & WARNINGS

Ensure a 2mm minimum ventilation gap below the

door is maintained.

Ensure all packaging is removed and disposed

obly.f responsi

Ensure the Knock-To-Pause module is oriented

correctly before attaching.

Reconnect the Knock-to-Pause

module to the UI 1 slot on the

wash controller as shown.

6

7

8

9

Reconnect the Earth wire to the

panel bracket.

Warning: Failure to reconnect the

Earth wire may result in electrical

shock or death.

Carefully fit the panels onto the

product. Re-insert both side pins

to secure panels in place.

Insert a crosshead driver into

the hole above each side pin

and rotate to adjust the panel

alignment. There is a maximum

travel distance of ± 1/16”(2mm).

Repeat for both sides if required.

For more information, visit www.fisherpaykel.com

!WARNING!

Electric Shock Hazard

Failure to follow this advice may result in

electrical shock or death.

• Read and follow the safety and warnings before

operating this appliance.

Double models

Repeat each step on both drawers.

Ensure a 8mm minimum ventilation gap below the door

is maintained.

COMPONENTS REQUIRED

Crosshead driverPliers

!WARNING!

Cut Hazard

Failure to use caution could result in injury.

• Take care: some edges may be sharp.

SERIES 11 models

SERIES 7 & 9 models

Remove both side pins with

pliers and carefully pull the panel

bracket down and out slightly.

1

2

3

4

Unplug knock-to-pause module

from the controller and remove

the earth wire from the bracket.

Remove the Knock-to-Pause

module from the back of

the bracket.

Install the handle to the panel

following the installation

guidance available for your

handle kit.

5Attach the Knock-to-Pause

module to the panel as shown.

Ensure the module is correctly

oriented and is not in contact

with the brackets before securing.

Produktspezifikationen