Focal FDP Sport V2 Bedienungsanleitung
Lies die bedienungsanleitung für Focal FDP Sport V2 (12 Seiten) kostenlos online; sie gehört zur Kategorie Empfänger. Dieses Handbuch wurde von 13 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 7 Bewertungen. Hast du eine Frage zu Focal FDP Sport V2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/12
1
Shared Controls
(All Channels)
Ch 1+2 Controls Refer to Figures 2B, 3B, or 4B for wiring diagrams
Refer to Figures 2A, 3A, or 4A for control diagramsCh 3+4 Controls
Figure 1 | N
CONFIGURATIONS
These are the 3 basic configurations that you will be using when installing your Focal FDP
SPORT V2. Pick the mode you will be running, turn to the appropriate page, and follow the
instructions to make the correct amp adjustments.
• 4 Channel Stereo Mode (Page 2)
• 2 Channel Bridged Stereo Mode (Page 4)
• 3 Channel Stereo and Bridged Mono Mode (Page 6)
FDP SPORT V2: 4-CH MOTO & ALL-TERRAIN AMP
OPERATION / CONFIGURATION MANUAL
FDP SPORT
V2
avigating the FDP Sport V2 Controls
2
4 CHANNEL STEREO MODE
INPUTS
• Under the “INPUTS”, move the switch to either position of “2IN or 4IN” depending on how many
inputs you are using to run the amp, 2 or 4.
• If you are only using one single pair of RCA’s from your source, then plug them into the Channel 3+4
or (REAR) RCA inputs, and select “2IN”
• If you are using the Harley Molex harness, then you are setting the switch to “2IN”
NOTE: RCA HARNESSFOR 2 CHANNEL INPUT USING THE (CH 1 & 2 INPUTS)
OR THE WITHOUT FACTORY REAR SPEAKERS:HARLEY HARNESS
You will need to use the patch harness. Set switch to and use input Channels 3 & 4 4 inch 2 IN
NORMAL/BRIDGED
• This switch should be set to “NORM”
SLOPE
• You can select the crossover slope you want for both channels, either a 6db/octave slope or a 12db/
octave slope.
• 12 db/octave is a sharper roll off slope, where the 6db/octave is more gradual roll off slope.
CHANNELS 1 & 2 CROSSOVER CONFIGURATION
• Channels 1+2 can be run in either Full Range, or in High Pass (HP) mode, using the bottom
row of controls. To run in Full Range mode, adjust the HP control down to the 10hz position.
• To run in HP mode, adjust the HP control to your desired HP frequency.
• Motorcycles normally use HP 120Hz.
CHANNELS 3 & 4 CROSSOVER CONFIGURATION
• You can select between Full Range (FR), Low Pass (LP), High Pass (HP), or Band Pass (BP) mode,
using the top row of controls.
• For FR, set MODE switch to HP, and adjust the HP control down to 10hz.
• For HP, set the MODE switch to HP, and adjust the HP control to set the HP frequency.
• For LP, set the MODE switch to LP. Adjust the HP control down to 10hz. Then adjust LP control to set
the LP frequency.
• For BP, set the MODE switch to LP, and adjust the LP control to the desired LP frequency. Adjust the
HP control to set HP frequency.
• Motorcycles normally use HP 120Hz.
GAIN CONTROL
• In this mode you will be using both gain controls to match your sources output level to your
amplifiers input.
SPEAKER OUTPUTS
• Following the wiring diagram in Figure 2B, wire your speakers to the appropriate output wires,
respecting the channels, and the + and – phasing.
3
Select “ ” Front Channel 1+2 ANORM djustments
Select the amount of inputs you are using
Rear Channel 3+4 Adjustments
FRONT SPEAKERS
+ – + –
REAR SPEAKERS
+ – + –
BATTERY
50 AMP FUSE
GROUND
AMP TURN ON
LEFT
Ch. 1
RIGHT
Ch. 2
LEFT
Ch. 3
RIGHT
Ch. 4
Figure 2B | 4 Channel Stereo Mode Wiring Diag mra
FDP SPORT
V2
FDP SPORT V2
Produktspezifikationen
| Marke: | Focal |
| Kategorie: | Empfänger |
| Modell: | FDP Sport V2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Focal FDP Sport V2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Empfänger Focal
28 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
19 August 2024
Bedienungsanleitung Empfänger
- Sogo
- LD Systems
- Hager
- Megasat
- Siig
- Asus
- Lectrosonics
- MuxLab
- Canor
- HiFi ROSE
- PreSonus
- Denson
- Mvision
- Medion
- Maxview
Neueste Bedienungsanleitung für -Kategorien-
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
15 Juni 2025
15 Juni 2025