Focusrite ISA 215 Bedienungsanleitung
Focusrite
Nicht kategorisiert
ISA 215
Lies die bedienungsanleitung für Focusrite ISA 215 (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 57 Personen als hilfreich bewertet und erhielt im Schnitt 4.2 Sterne aus 29 Bewertungen. Hast du eine Frage zu Focusrite ISA 215 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/1
ISA 215
Dual Channel Mic-pre and Equaliser
The controls on this module are identical for both channels and are described from left to right along the
front panel .
Mains Power Switch - this is a mini rocker switch . When switched on , two LEDs indicate correct
operation of the bipolar 15volt power rails .
Phase Invert Switch - A latching , illuminated push switch which inverts the phase of the input signal by
180°
Overload Indicator - illuminates when the peak of the signal level reaches or exceeds +20dB , which is
6dB prior to the onset of clipping.
High Pass Filter - Frequency selection is by a six way rotary switch with the highest position switching
the filter out .
Low Pass Filter - Situated to the right of the High Pass Filter , frequency selection is again by a six way
rotary switch with the highest position switching the filter out . Both filters have a rolloff of -18dB /
octave and their operation is independent of the All EQ In switch .
All Eq In switch - An illuminated , latching push switch situated at the bottom left of the Low
Frequency Shelving section . This is a master EQ switch which inserts the EQ circuitry into the signal
path . This switch must be engaged to enable operation of the other EQ In switches .
Low and High Frequency Shelving Stages - The Eq In switch , an illuminated , latching push switch
inserts the two equaliser stages into the signal path . This switch only operates when the All EQ In
switch is engaged .
The controls for these two sections are identical , except for the frequency range of the stages. Each
stage has a continuously variable boost and cut control with centre detent providing up to 16dB cut or
boost . Each stage has a six way rotary switch for frequency selection with six frequencies available for
each .
Low Mid and High Mid Frequency Parametric Stages - The Eq In switch , an illuminated , latching push
switch inserts the two equaliser stages into the signal path . Again this switch only operates when the All
EQ In switch is engaged .
The controls for these two sections are identical , except for the frequency range of the stages. Each
stage has a continuously variable boost and cut control with centre detent providing up to 16dB cut or
boost .
There is a frequency sweep control with two ranges, the higher range being available when the x 3
switch is engaged . Last but not least is a variable Q or bandwidth control.
Line Input - Selected when the momentary push switch “Line” is illuminated . A seven way rotary
switch selects the Line Input sensitivity , ranging from -18dB to +18dB in 6dB steps
Mic Input - Selected when the momentary push switch “Mic” is illuminated . An eleven way rotary
switch selects the Mic Input sensitivity , ranging from -60dB to 0dB in 6dB steps .
+48v - An illuminated , latching push switch providing phantom power to the Mic input XLR
Trim - A continuously variable control providing up to 12dB of gain trim which can be applied to either
Line or Mic input .
Produktspezifikationen
| Marke: | Focusrite |
| Kategorie: | Nicht kategorisiert |
| Modell: | ISA 215 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Focusrite ISA 215 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Focusrite
28 September 2024
20 September 2024
16 September 2024
9 September 2024
8 September 2024
1 September 2024
29 August 2024
29 August 2024
29 August 2024
29 August 2024
Bedienungsanleitung Nicht kategorisiert
- Befaco
- Start International
- Zenec
- CELLFAST
- NEP
- Dangerous Music
- Vanson
- Dreame
- Ariete
- Turbo Scrub
- AVID
- Profile
- Marantz
- Estella
- Sherlock
Neueste Bedienungsanleitung für -Kategorien-
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025