Garde XL 181CONSFBSS Bedienungsanleitung

Lies die bedienungsanleitung für Garde XL 181CONSFBSS (1 Seiten) kostenlos online; sie gehört zur Kategorie Dosenöffner. Dieses Handbuch wurde von 30 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 15.5 Bewertungen. Hast du eine Frage zu Garde XL 181CONSFBSS oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

QUICK START GU

#10 CAN OPENER

SAFETY INSTRUCTIONS

MODELS

OPERATION

CLEANING

REPLACING THE KNIFE

REPLACING THE GEAR

REPLACEMENT PARTS

These parts can be purchased from the same location as the can opener.

03/2023

It is recommended the knife and gear are replaced

at the same time for optimal performance.

CAUTION

Blade is sharp. Use caution when cleaning and changing.

CAUTION

The can opener can cause the lid and edges of the can to

be sharp. Use caution when handling newly opened can.

181CONSFBSS - Stainless Steel Base

181CONSFBST - Plated Steel Base

181CONSFNB - No Base

1. Position the can you are opening on the counter on top

of the base with the lip of the can touching the

can opener.

2. Line up the knife on the inside lip of the can.

3. With the handle upright, punch down so the knife

punctures the can’s lid.

4. Push the handle down so it is parallel with the counter

and begin turning the handle to open the can.

5. Once the lid is separated, safely remove it from the can.

NOTE: Avoid touching the sharp edges of the lid that

were created while opening the can.

6. Pull the can opener up and move the can away from

the opener.

1. The can opener’s surface and knife should be

cleaned regularly using a food safe sanitizer.

Recommended: Noble Chemical QuikSan

(147QUIKSAN).

2. Remove ring pin from blade housing and remove

blade assembly.

3. Thoroughly clean and dry blade assembly.

Use a toothbrush-style brush to clean the inside

of the blade housing.

4. Re-attach blade assembly to blade housing

with ring pin.

5. After cleaning, apply a food-safe oil to the gear

to keep it turning smoothly.

1. Using either a Phillips or at head screwdriver, remove

the (2) screws that connect the knife to the opener.

2. Remove and discard the old knife while keeping the

knife support plate.

3. Position the new knife in line with the holes and place

the support plate on top of the knife.

4. Use the screwdriver to tighten the screws.

1. Insert the can opener into the base for leverage.

2. Use a at head screwdriver to hold the gear in place by

jamming it into the teeth of the old gear. You will need

to apply enough pressure to hold the gear in place.

3. With the screwdriver in place, begin turning the handle

counterclockwise. You should feel the tension in the

spring ease up and the gear will come loose after a

few turns.

4. Remove the old gear and keep the washer. Insert the

new gear with the washer on top.

5. Turn the handle clockwise until the handle connects

to the shaft below the gear. The spring should tighten

back up.

ITEM NUMBERDESCRIPTION

181BASE1PSMAPlated Steel Base

181BASE1SSMAStainless Steel Base

181NSFKNIFMAKnife

181NSFBGRPKITKnife & Gear Kit

181COM1SUPMAKnife Support

181CO1SCRWMAScrew Set

181COM1GEARMAGear

181CO1WASHMAWasher

Produktspezifikationen