Hager WGDEDR500 Bedienungsanleitung
Hager
Nicht kategorisiert
WGDEDR500
Lies die bedienungsanleitung für Hager WGDEDR500 (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 31 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 16 Bewertungen. Hast du eine Frage zu Hager WGDEDR500 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/4
www.hager.com
Safety instructions
Electrical equipment must only be installed and assembled by a qualied
electrician in accordance with the relevant installation standards, regulations,
directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to
the device, re or other hazards.
Function
Switching and dimming of incandescent lamps, high-voltage halogen lamps as well as
dimmable electronic transformers (marked with L, C) with halogen lamps.
Recommendation: Use Osram transformator ET-PARROT 105/220…240 I.
Correct use
- For the ush-mounted installation in standard wall boxes
(recommended wall box depth ≥ 35 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Product characteristics
- Dimming principle: phase cut-on
- Change-over switch in combination with change-over switch possible.
- Short-circuit proof and overload proof
Technical data
Rated voltage: 230 V~
Frequency: 50/60 Hz
230 V incandescent and halogen lamps: 40 ... 500 W
Electronic transformers (marked with L,C): 40 ... 250 W
Conductor cross-section of screw terminals: max. 3 x 1.5 mm²
Distance of xing holes: 60.3 mm
Operating temperature: -5 ... +45 °C
Relative humidity (without condensation): 5 ... 95 % (at 25 °C)
Standards: BS EN 60669-2-1, IEC 60669-2-1
Mixed operation of 230 V incandescent and halogen lamps as well as electronic
transformers (marked with L,C until smallest maximum load possible.
40-500W Single dimmer
Hager Dream
Installation and operating
instructions
2
Operating the device
The switch-on brightness level depends on the position of the dimmer.
Information for electricians
Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and
cover all live parts in the area!
ç
Preparing the device for installation
Notches
Cover
1
Carefully loosen the cover on the notches with a at-blade screwdriver (1).
Remove the cover.
3
Connecting the device
L1
L2
L
N
L1
L2
L
N
2A 2B
Strip connection cables approx. 11 mm.
Wire the dimmer according to the connection diagram (2A). Can be installed alter-
natively with a change-over switch ( ).2B
Installing the device into the wall box
3
After wiring, x the dimmer with the two screws attached into the wall box (3).
Produktspezifikationen
| Marke: | Hager |
| Kategorie: | Nicht kategorisiert |
| Modell: | WGDEDR500 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Hager WGDEDR500 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Hager
22 Juni 2025
22 Juni 2025
22 Juni 2025
22 Juni 2025
22 Juni 2025
22 Juni 2025
22 Juni 2025
21 Juni 2025
21 Juni 2025
21 Juni 2025
Bedienungsanleitung Nicht kategorisiert
- Zeiss
- PTZ Optics
- Powerblade
- Venta
- Lehle
- Cramer
- Minix
- MIOPS
- Taco Tuesday
- Technaxx
- Dometic
- Ortofon
- GAO
- Seagate
- Digital Juice
Neueste Bedienungsanleitung für -Kategorien-
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025
1 Juli 2025