Honeywell CT50K1028 Bedienungsanleitung

Honeywell Thermostat CT50K1028

Lies die bedienungsanleitung für Honeywell CT50K1028 (16 Seiten) kostenlos online; sie gehört zur Kategorie Thermostat. Dieses Handbuch wurde von 48 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 24.5 Bewertungen. Hast du eine Frage zu Honeywell CT50K1028 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF
Seite 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT50 Series
Thermostat
® U.S. Registered Trademark. Patents pending.
Copyright © 2009 Honeywell International Inc.
All rights reserved.
M23785
69-2040EFS-01
M23786
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
TURN OFF POWER at heating/cooling system (or fuse/circuit-breaker panel).
Remove cover and thermostat, but leave wallplate with wires attached.
Temperature Control Range
• 45°–95°F(7°–35°C)
• 35°–85°F(2°–29°C);selectmodels;forgaragesorotheroutbuildings.
Is there a sealed tube containing mercury?
If so, see mercury notice below.
Leave wallplate in place.
Old thermostat Cover
Check package contents:
• Thermostat
• Wallanchors&screws(2each)
• Wirelabels
Before you begin, make sure you have:
• No.2Phillips&smallpocketscrewdrivers
• Hammer
• Level(optional)
• Pencil
• Drillandbit(3/16”fordrywall,7/32”for
plaster)
Getting started
Remove your old thermostat
Vertical Mount:
CT50(24Vacheatingsystems)
CT51(24Vacheatingandcoolingsystems)
CT53(750mVor12Vdcheatingsystems)
Horizontal Mount:
CT54(24Vacheatingsystems)
CT55(24Vacheatingandcoolingsystems)
CT50 Series • Owner's Manual
69-2040EFS—01 2
M23789
M23787
M23790
M23788
Wrapsuppliedlabelssecurelyaroundeachwire.Do not let wires fall into wall opening!
IGNORE WIRE COLORS: Use only letter
designations to identify wire types.
ForCT51/CT55: If your old
thermostathas7ormorewires
( ), not counting terminals C or C1
you may have purchased the
wrong replacement thermostat.
Stopnowandcall1-800-468-1502
for advice.
CT50/CT53/CT54
1. Pullwires
through base.
2. Level base if
desired.
3. Markpositions
of both screw
holes.
ForCT50/CT53/CT54: If your old
thermostathas3ormorewires
( ), not counting terminals C or C1
you may have purchased the
wrong replacement thermostat.
Stopnowandcall1-800-468-1502
for advice.
Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with
the label matching the letter on your old thermostat. (Adhesive labels are supplied in your
thermostat package.)
Remove the old wallplate only after all wires are labeled. Be careful not to let loose wires fall
into the wall opening.
Label wires and remove old wallplate
Mark mounting position
CT51/CT55
CT50/CT53/CT54 CT51/CT55
English: Page 1 • Français : Page 6 • Español: Página 11
3 69-2040EFS—01
Wiring CT50/CT53/CT54
• 2-wire heat-only system: Connect one
wire to terminal, one wire to terminal.R W
Wiring CT51/CT55
[1]IfwireswillbeconnectedtobothR and Rc
terminals, remove the metal jumper.
[2]DonotconnectbothO B and if you have a
heat pump. Connect only the O Bwire.Wrap
wire with electrical tape and do not use.
[3]Donotuse .WrapbareendofwireC X B, or
with electrical tape.
1. Drillholesatpencil-marked
locations(3/16”holesfor
drywall,7/32”holesfor
plaster).
2. Use hammer to tap anchors
intoholesuntilushwithwall.
3. Pullwiresthroughthermostat
base and insert screws.
Check level if desired, then
tighten screws.
Mount thermostat base
1. Matcheachlabeledwirewithsame
letter on terminal.
2. Use a screwdriver to loosen screw
terminals, insert bare wires beneath
screws, then tighten screws.
3. Pushanyexcesswirebackintothe
wall opening.
Labels don't match?
If labels do not match letters on
thermostat, see table below.
Existing wires Connect to:
R RH 4• • • V Terminal “R” [1]
Rc Terminal “Rc” [1]
O Terminal “O” [2]
B Terminal “B” [2]
G F• Terminal “G”
W W1 H• • Terminal “W”
Y Y1 M• • Terminal “Y”
C X B Do not use• •  [3]
CT51/CT55
CT50/CT53/CT54
Connect wires

Produktspezifikationen

Marke: Honeywell
Kategorie: Thermostat
Modell: CT50K1028

Brauchst du Hilfe?

Wenn Sie Hilfe mit Honeywell CT50K1028 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Thermostat Honeywell

Honeywell

Honeywell Round on-off T87G1006 Bedienungsanleitung

5 Oktober 2024
Honeywell

Honeywell Day Night Round T8700A Bedienungsanleitung

4 Oktober 2024
Honeywell

Honeywell T822L1000/U Bedienungsanleitung

30 September 2024
Honeywell

Honeywell CT53K1006/E1 Bedienungsanleitung

27 September 2024
Honeywell

Honeywell TH6320WF2003/U Bedienungsanleitung

24 September 2024
Honeywell

Honeywell SMHOM8610KIT Bedienungsanleitung

15 September 2024
Honeywell

Honeywell Focus Pro Bedienungsanleitung

13 September 2024
Honeywell

Honeywell TH6220WF2006/U Bedienungsanleitung

13 September 2024
Honeywell

Honeywell T8775C1005/U Bedienungsanleitung

12 September 2024
Honeywell

Honeywell TH3110D1016/U Bedienungsanleitung

8 September 2024

Bedienungsanleitung Thermostat

Neueste Bedienungsanleitung für -Kategorien-

Warmup

Warmup 5iE Bedienungsanleitung

17 Juni 2025
Warmup

Warmup +Kit Bedienungsanleitung

16 Juni 2025
Nobo

Nobo Connect SWT-IZB Bedienungsanleitung

16 Juni 2025
Nobo

Nobo Connect SWT-IZW Bedienungsanleitung

15 Juni 2025
Salus

Salus VS30W Bedienungsanleitung

14 Juni 2025
Danfoss

Danfoss React M30x1.5 Bedienungsanleitung

14 Juni 2025
Meross

Meross MTS150 Bedienungsanleitung

12 Juni 2025
Meross

Meross MCA100 Bedienungsanleitung

12 Juni 2025
Meross

Meross MTS150HK Bedienungsanleitung

12 Juni 2025
Mainstreet Equipment

Mainstreet Equipment GMC-12 Bedienungsanleitung

8 Juni 2025