Honeywell T822K1034/U Bedienungsanleitung
Honeywell
Thermostat
T822K1034/U
Lies die bedienungsanleitung für Honeywell T822K1034/U (16 Seiten) kostenlos online; sie gehört zur Kategorie Thermostat. Dieses Handbuch wurde von 16 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 8.5 Bewertungen. Hast du eine Frage zu Honeywell T822K1034/U oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
T822/T827 Series
Thermostat
® U.S. Registered Trademark. Patents pending.
Copyright © 2019 Resideo Technologies Inc.
All rights reserved.
M37965
69-2251EFS-03
Check package contents:
• Thermostat
• Wall anchors & screws (2 each)
Before you begin, make sure you have:
• No. 2 Phillips & small pocket screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32” for
plaster)
Pre-installation checklist
This manual covers the following models*:
T822K,L • T827K
* Images are for reference only and may not represent the actual thermostat.
Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
T822/T827 Series • Owner's Manual
69-2251EFS—03 2
System Types
• Gas or oil
• Warm air, hot water, high-efficiency furnaces, heat pumps, steam, gravity
• Normally closed hot water valves (T822K)
• 2-wire cooling systems (T822L)
• Normally open hot water valves (T822L)
System Settings
• Heat, Off (select models only)
Fan Settings
• Auto, On (select models only)
Specifications
Temperature Control Range
• 45° to 95°F (7° to 35°C)
• 35° to 85°F (2° to 29°C)*
Operating Ambient Temperature
• 0° to 120°F (18° to 49°C)
Operating Relative Humidity
• 5% to 90% (non-condensing)
Dimensions (vertical model)
• 2.88W x 4.75H x 1.5D (inches)
• 73W x 121H x 38D (mm)
Dimensions (horizontal model)
• 4.75W x 2.88H x 1.5D (inches)
• 121W x73H x 38D (mm)
Product application
This thermostat provides control of:
• 24 Vac heating systems (T822K)
• 750 mV or 12 Vdc heating systems (T827K)
• 24 Vac cooling systems (T822L)
* CAUTION: Do not use a product with
this temperature control range in
a home. Temperatures at or below
freezing can occur. A product with this
temperature range is for use in areas
where temperatures below freezing
can occur, such as a garage.
Electrical Ratings
Terminal Voltage (50/60Hz) Running Current
W1 Heating 2030 Vac 0.021.2 A
W2 (Powerpile) 750 mVdc 100 mAdc
W2 (DC Powered) 12 Vdc 0.1 A
Y3 Cooling 2030 Vac 0.021.2 A
Y3 Normally open zone valve 2030 Vac 0.021.2 A
1 T822K
2 T827K
3 T822L
English: Page 1 • Français : Page 6 • Español: Página 11
3 69-2251EFS—03
M27305
M27306
1. Pull wires through wire hole.
Position base on wall, level
and mark hole positions.
2. Drill holes (3/16” holes for
drywall, 7/32” holes for plas-
ter), then tap in supplied wall
anchors.
3. Pull wires through base, posi-
tion over anchors, and insert
screws. Check level if desired,
then tighten screws.
Base installation
1. Loosen screw terminals, insert bare wires
beneath screws, then re-tighten screws.
2. Push any excess wire back into the wall
opening
3. Plug the wall opening with nonflammable
insulation to prevent drafts from affecting
thermostat operation.
Terminal Designations
R R power. Connect to 24 V hot on secondary
side of heating/cooling transformer or R on
furnace/boiler for 750 mV systems.
W1 Heat relay.
Y2 Cool relay, or
normally open hot water valve.
G Fan relay (select models only)
1 T822K and T827K
2 T822L
Wire specifications
Use 18-gauge thermostat wire. Shielded
cable is not required.
Wiring
Produktspezifikationen
| Marke: | Honeywell |
| Kategorie: | Thermostat |
| Modell: | T822K1034/U |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Honeywell T822K1034/U benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Thermostat Honeywell
5 Oktober 2024
4 Oktober 2024
30 September 2024
27 September 2024
24 September 2024
15 September 2024
13 September 2024
13 September 2024
12 September 2024
8 September 2024
Bedienungsanleitung Thermostat
- UPM
- Panasonic
- Emerson
- JUNG
- Mikoterm
- Etherma
- Basetech
- Ferroli
- Johnson Control
- Wolf
- Taurus
- POER
- Lowes
- Tado
- Sinustec
Neueste Bedienungsanleitung für -Kategorien-
16 Juni 2025
16 Juni 2025
15 Juni 2025
14 Juni 2025
14 Juni 2025
12 Juni 2025
12 Juni 2025
12 Juni 2025
8 Juni 2025
8 Juni 2025