IFM E33701 Bedienungsanleitung


Lies die bedienungsanleitung für IFM E33701 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 13 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 7 Bewertungen. Hast du eine Frage zu IFM E33701 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/2
Installation instructions
Aseptoflex Vario adapter
with metal-to-metal seal
E337xx
E338xx
704863/01 02/2011
UK
2
1 Installation sensor - adapter
Screw the sensor into the adapter
until it is hand-tight. When doing
so, avoid mechanical effects on the
sealing areas, the hygienic area and
the pressure measuring cell.
The inside of the adapter is coated with
parylene C (USP class VI). Therefore
it is not necessary to use additional
lubricants.
B
Clamp the sensor + adapter into a
clamping device (B). Tighten the
clamping device only slightly so that
the adapter does not warp.
Tighten the sensor using a spanner
until you can feel the end stop (this
corresponds to a maximum tighten-
ing torque of 35 Nm). Note: Further
tightening may affect the sealing
effect.
2 Mounting to the process connection
Fix the sensor + adapter are fixed to the process connection using a fixing ele-
ment (coupling nut, clamp flange, etc.).
If it is not possible to slide the fixing element down over the top of the unit: slide
it up over the bottom of the unit before the adapter is mounted.
Use in hygienic areas to EHEDG:
Make sure that the sensors are integrated into the system in accord-
ance with EHEDG.


Produktspezifikationen

Marke: IFM
Kategorie: Nicht kategorisiert
Modell: E33701

Brauchst du Hilfe?

Wenn Sie Hilfe mit IFM E33701 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten