InSinkErator HWT-F1000S Bedienungsanleitung
InSinkErator
Wasserspender
HWT-F1000S
Lies die bedienungsanleitung für InSinkErator HWT-F1000S (51 Seiten) kostenlos online; sie gehört zur Kategorie Wasserspender. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 1.5 Bewertungen. Hast du eine Frage zu InSinkErator HWT-F1000S oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/51
We are delighted that you have chosen the InSinkErator
®
Instant Hot Water Dispenser
to be a part of your home. This unique appliance will save you time and effort in the kitchen,
and you’ll enjoy discovering new uses for it each day. That’s exactly why millions of people are
now using an InSinkErator Instant Hot Water Dispenser.
We are confident that by following our step-by-step instructions, you’ll soon be enjoying the
convenience of instant hot water.
For your satisfaction and safety, read all instructions, cautions and warnings before installing or using this instant
hot water dispenser.
This particular unit is not intended for commercial use.
Make sure that all electrical wiring and connections conform to local codes.
A standard 115-volt grounded electrical outlet is required under the sink for the dispenser’s electrical power.
The wall outlet powering your dispenser must have power supplied to it continuously.
This outlet must be fused and should not be controlled by the same wall switch that operates the disposer, unless
you have a SinkTop Switch
™
from InSinkErator
®
.
It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system.
If you suspect elevated levels of chlorine in your water, or your water has a rusty appearance before the installation
of this unit, it is recommended to use our water filtration system.
This product contains stainless steel. The manufacturer cannot guarantee against rusty water because of the
number of factors that are involved beyond the manufacturer’s control. However, the sudden appearance of rusty
water discharged from the hot water dispenser may indicate the need for service or replacement of this product.
The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa). If it does, this will
prevent your unit from operating properly.
Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
n Phillips and flat blade screwdrivers
n Pencil
n Tape measure
n Level
Equipment You May Need:
Equipment Required:
n Drill
n T-fitting
n Dedicated control valve
n Adjustable wrench
n Philips Screw Driver
n Pencil
n Tape Measure
Anchors for drywall
Hole saw
Basin wrench
Hole punch
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and a
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step 1B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄4" - 1
1
⁄2" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
WHAT YOU NEED TO GET STARTED
2
Produktspezifikationen
| Marke: | InSinkErator |
| Kategorie: | Wasserspender |
| Modell: | HWT-F1000S |
Brauchst du Hilfe?
Wenn Sie Hilfe mit InSinkErator HWT-F1000S benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Wasserspender InSinkErator
26 Juli 2025
25 Juli 2025
25 Juli 2025
17 August 2024
Bedienungsanleitung Wasserspender
- Ernesto
- Hatco
- Royal Sovereign
- Philips
- Panasonic
- Waring Commercial
- Hiberg
- Nutrichef
- Imarflex
- Emerio
- Tiger
- Oasis
- Curtis
- Servend
- SPT
Neueste Bedienungsanleitung für -Kategorien-
26 Juli 2025
26 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
24 Juli 2025
20 Juli 2025