Jensen JDC218BT Bedienungsanleitung

Jensen Empfänger JDC218BT

Lies die bedienungsanleitung für Jensen JDC218BT (26 Seiten) kostenlos online; sie gehört zur Kategorie Empfänger. Dieses Handbuch wurde von 29 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 15 Bewertungen. Hast du eine Frage zu Jensen JDC218BT oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/26
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver
JDC218BT
2
JDC218BT INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
Disconnect negative battery terminal. Consult a qualified technician for instructions.
Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
Remove trim ring from unit.
Remove 2 transit screws located on top of the unit.
Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.
Install mounting sleeve into opening, bending tabs to secure.
Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
Certain vehicles may require an installation kit and/or wiring
harness adapter (sold separately).
Test for correct operation and slide into mounting sleeve to secure.
Snap trim ring into place.
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
3
JDC218BT INSTALLATION
Wiring Diagram
FUSE
When replacing the
fuse, make sure new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio.
The uses
one 10 amp ATM fuse
located beside the wiring
connector.
Antenna
Connector
10 AMP
AGC Fuse
JDC218BT
AGC


Produktspezifikationen

Marke: Jensen
Kategorie: Empfänger
Modell: JDC218BT

Brauchst du Hilfe?

Wenn Sie Hilfe mit Jensen JDC218BT benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten