Joy-it RB-TFT1.8 Bedienungsanleitung

Joy-it Monitor RB-TFT1.8

Lies die bedienungsanleitung für Joy-it RB-TFT1.8 (12 Seiten) kostenlos online; sie gehört zur Kategorie Monitor. Dieses Handbuch wurde von 8 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 4.5 Bewertungen. Hast du eine Frage zu Joy-it RB-TFT1.8 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/12
1,8 " TFT DISPLAY-
RB-TFT1.8
1. GENERAL INFORMATION
Dear customer,
thank you for choosing our product. In the following, we will show you
how to use this device.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
2. USAGE WITH RASPBERRY PI
2.1 Connection
TFT Raspberry Pi
VCC 3,3 V
GND GND
SCL GPIO 11
(SCLK)
SDA GPIO 10
(MOSI)
RS/DC GPIO 25
RES GPIO 24
CS GPIO 8
(CE0)
On the back of the display is an SD card slot, which can be accessed with
the other pins.
2.2 Installation
We use with the Raspberry Pi the library Adafruit_CircuitPython
_RGB_Display Adafruit from , which was published under the
MIT-
License
.
First, install so that you can perform all installations without any pip
problems. To do this, run the following command in your console.
sudo apt get install python3 pip- -
Now enable SPI on your Raspberry Pi. To do this, execute the following
command.
sudo raspi config-
Now go to
1 Interface Options
P4 SPI
.
Answer the question
Would you like the SPI interface to be enabled?
with
<Yes>
to activate SPI.
Now install the library using the following commands.
sudo pip3 install adafruit circuitpython rgb display- - -
sudo apt get install fonts dejavu- -
sudo apt get install python3 pil- -


Produktspezifikationen

Marke: Joy-it
Kategorie: Monitor
Modell: RB-TFT1.8

Brauchst du Hilfe?

Wenn Sie Hilfe mit Joy-it RB-TFT1.8 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten