LiftMaster 041B8861 Bedienungsanleitung

Lies die bedienungsanleitung für LiftMaster 041B8861 (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 24 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 3 Bewertungen. Hast du eine Frage zu LiftMaster 041B8861 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

A

B

B

B

C

E

F

D

G

H

G

G

G

Travel Module Replacement Kit

Model 041B8861

Specifications

Volts . . . . . . . .. . . . . . .. . . . . .. . . . . .. . . . . . .. .120 Vac - 60 Hz, Only

Current1.5 AMP ............................................

Rated Load385 in/ lb./sec. . . . . .. . . . . . .. . . . . .. . . . . . .. . . . . .. . . . .

WARNING: This product can expose you to chemicals including

lead, which are known to the State of California to cause cancer or

birth defects or other reproductive harm. For more information go

to www.P65Warnings.ca.gov

To prevent possible SERIOUS INJURY or DEATH:

• Disconnect ALL electric and battery power BEFORE performing ANY

service or maintenance.

To prevent damage to the receiver/logic board, DO NOT touch printed

circuit board of replacement receiver/logic board during installation.

ALWAYS wear protective gloves and eye protection when changing the

battery or working around the battery compartment.

Remove the two screws securing 9.

the travel module to the opener.

Disconnect 5-wire connector from the

travel module. Slide or shift the travel

module towards the front of the unit

and pull out .(H)

10.Align the mounting tabs to the side

panel. Push in the travel module.

Secure travel module with screw.

Reconnect 5-wire connector.

11.Reinstall the cover. Verify that the

tabs in the cover align with the holes

in the top of the chassis. Route the

wire harnesses and wires through the

cover.

12.Install the receiver logic board and

connect the wire harnesses. Ensure

the wire harnesses are connected

properly. Route the antenna through

the channel in the cover. Install

receiver logic board cover.

13.Reconnect the wires to the quick

connect terminals .(C)

14.Install the battery (if applicable) and

connect the battery connectors. Install

the battery cover.

15.Reconnect power.

Refer to your manual to reset your

travel and force settings.

8.Remove the four screws

securing the cover to the

chassis .(G)

6.Unplug the wire harnesses

from the receiver logic

board .(E)

7.Remove the four screws

securing the receiver logic

board, remove the logic

board , and set aside.(F)

4.Label wires for reinstallation.

Disconnect the wires from the quick

connect terminals .(C)

NOTE: If there is a resistor located on

the green wire traps, do not remove.

5.Remove the receiver logic board

cover .(D)

1.Disconnect power.

2. Open the front panel .(A)

3.Remove the battery cover.

Disconnect the battery (if

applicable). Remove the

battery and set aside. (B)

Included Items

Travel Module (1)

Screws (2)

Wire Harness (2)

- 10” for non-Wi-Fi Units

- 16” for Wi-Fi Units

Use the appropriate wire harness, referencing the existing harness for

correct length.

1

Produktspezifikationen