LiftMaster 813LM Bedienungsanleitung

Lies die bedienungsanleitung für LiftMaster 813LM (8 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 19 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 10 Bewertungen. Hast du eine Frage zu LiftMaster 813LM oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

To prevent possible SERIOUS INJURY or

DEATH from a moving gate or garage door:

• ALWAYS keep remote controls out of

reach of children. NEVER permit children

to operate, or play with remote control

transmitters.

• Activate gate or door ONLY when it can be

seen clearly, is properly adjusted, and

there are no obstructions to door travel.

• ALWAYS keep gate or garage door in sight

until completely closed. NEVER permit

anyone to cross path of moving gate or

door.

Introduction

This product is for use with models 850LM and

860LM universal receivers as well as any

Security+ 2.0®compatible LiftMaster gate

operators. Depending on the receiver channel,

you may program up to 20 or 50 remote control

dip switch configurations to your receiver. To

exceed the 20/50 limit, match the dip switches

in the new remote control to the dip switches in

an existing remote control.

GATE KEY REMOTE CONTROLS

MODELS 811LM AND 813LM

Set the Dip Switches

1 Slide the cover open to access the dip

switches in the remote control.

2 Use a pen or screwdriver to slide the dip

switches to any position you want (ON or

OFF).

1 Press and release the Learn button for the

selected channel on the receiver. The

corresponding LED will glow steadily for 30

seconds.

2 Within 30 seconds press and hold the button

on the remote control that you wish to

program to the receiver.

3 Release the remote control button when the

LED on the receiver blinks, then turns off.

Programming is complete.

Repeat the steps above for each remote control

you would like to program.

If you would like to program an 813LM as an

OPEN, CLOSE, STOP, refer to the 850LM

receiver manual.

Programming

Learn Buttons

811LM 813LM

For programming to the 860LM receiver or to a

Security+ 2.0®compatible gate operator, please

refer to the receiver/operator instructions manual

for location of the learn button(s).

WARNING: This product can expose you to chemicals including lead, which are known to

the State of California to cause cancer or birth defects or other reproductive harm. For more

information go to www.P65Warnings.ca.gov

Produktspezifikationen