Mean Well NDR-75-24 Bedienungsanleitung

Lies die bedienungsanleitung für Mean Well NDR-75-24 (3 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 12 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 3 Bewertungen. Hast du eine Frage zu Mean Well NDR-75-24 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Installaon Manual

Type：

：

：

：：NDR DIN rail power supplySeriesNDR-75,

（

（

（

（（ ：

：

：

：： 120, 240, 480）

）

）

））

N-- INPUT: -240VAC 1.6A 50/60Hz OUTPUT: V 6.3A DR751210012

N-- INPUT: -240VAC 1.6A 50/60Hz OUTPUT: V 3.2A DR752410024

N-- INPUT: -240VAC 1.6A 50/60Hz OUTPUT: V 1.6A DR754810024

N-120- INPUT: -240VAC 2.6A 50/60Hz OUTPUT: V A DR121001210

N-120- INPUT: -240VAC 2.6A 50/60Hz OUTPUT: V 5A DR2410024

N-120- INPUT: -240VAC 2.6A 50/60Hz OUTPUT: V 2.5A DR4810048

NDR-240- INPUT: -240VAC 2.8A 50/60Hz OUTPUT: V A 241002410

NDR-240- INPUT: -240VAC 2.8A 50/60Hz OUTPUT: V 5A 4810048

NDR-480- INPUT: -240VAC 5.3A 50/60Hz OUTPUT: V A 241002420

NDR-480- INPUT: -240VAC 5.3A 50/60Hz OUTPUT: V A 481004810

Introducon

NDR is a DIN rail power supply series with an economical price and slim design. Like other Mean WellDIN series, ’s

they can be mounted on a TS35 Standard DIN rail.

Installaon

（ ）1Always allow good venlaon clearances, 5mm le and right, 40mm above and 20mm below, around the unit

in use to prevent it from overheang. Also a 10-15 cm clearance must be kept when the adjacent device is a

heat source.

（ ）2The appropriate mounng orientaon for the unit is vercal, the input terminals the bottom and output on at

the top. Mounng orientaons other than that, such as upside down, horizontal, or table-top mounng, is not

allowed.

（ ）3Use copper wire only, and recommended wires are shown as below.

AWG

18

16

14

12

Rated Current of

Equipment (Amp)

7A

10A

15A

20A

Cross-secon of

Lead(mm2 )

0.8

1.3

2.1

3.3

Note: Current each wire carries should be de-rated to 80% of the current suggested

above when using 5 or more wires connected to the unit.

Make sure that all strands of each stranded wire enter the terminal connecon and the screw terminals are

securely xed to prevent poor contact. If the power supply possesses mul-output terminals, please make

sure each contact is connected to wires to prevent too much current stress on a single contact.

（ ）4Use wires that can withstand temperatures of at least 80°C, such as UL1007.

（ ）5Recommended wire strapping length m (0.197. is 5m”)

（ ）6Recommended screwdriver is 3, sloed type.mm

Produktspezifikationen