Metra 99-8153 Bedienungsanleitung


Lies die bedienungsanleitung für Metra 99-8153 (8 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 23 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 12 Bewertungen. Hast du eine Frage zu Metra 99-8153 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/8
INSTALLATION INSTRUCTIONS FOR PART 99-8153
APPLICATIONS
LEXUS LS SERIES
1995-2000
NOT FOR USE IN VEHICLES
WITH FACTORY NAVIGATION
KIT FEATURES
DIN Radio Provision with Pocket
ISO Mount Radio Provision with Pocket
A) Radio Housing B) Radio Housing Brackets C) ISO Brackets D) Trim Plate
KIT COMPONENTS
AB
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
Phillips Screwdriver Socket Set
1-800-221-0932
© COPYRIGHT 2008 METRA ELECTRONICS CORPORATION
www.metraonline.com
99-8153
CD
Dash Disassembly
-
Lexus LS Series 1995-2000 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1
Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Kit Assembly
- DIN Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
- ISO Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . .4
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
TABLE OF CONTENTS
99-8153
*Note:
Refer also to the instructions included with the aftermarket radio.
99-8153 DASH DISASSEMBLY
LEXUS LS SERIES 1995-2000
D
1 2 3 4 56
SCAN P.SCAN
TUNE
SEEK
TRACK
BASS MID TREBLE BALANCE FADER
AM
FM1/2
TAPE
CD
TEMP TEMP
FRONT REAR A/C
OFF AUTO MODE DUAL
PASSENGER
1 2 3 4 5 6
SCAN P.SCAN
TUNE
SEEK
TRACK
BASS MID TRE B LE BALANCE FADE R
AM
FM1/2
TAPE
CD
TEMP TEMP
FRONT REAR A/C
OFF AUTO MODE DUAL
PASSENGER
ONE SCREW
ON EACH
SIDE
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Starting at rear of panel surrounding
the shifter carefully pry up and out to
remove entire panel including ashtray.
(
Figure A)
2
Using a panel removal tool or small
flat blade screwdriver gently pry out
on the top of the A/C vent assembly
(including clock) and remove.
(Figure B)
3
Remove (4) screws securing the fac-
tory radio/climate control assembly.
Unplug and remove the assembly.
(Figure C)
4
Remove (2) screws securing factory
climate control to the assembly.
Remove the climate control from the
assembly and retain it for re-use dur-
ing kit assembly. (
Figure D)
5
Continue to kit assembly.
A
B
C


Produktspezifikationen

Marke: Metra
Kategorie: Nicht kategorisiert
Modell: 99-8153

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra 99-8153 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten