Metra Axxess AX-ADCH02 Bedienungsanleitung

Lies die bedienungsanleitung für Metra Axxess AX-ADCH02 (16 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 14 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 7.5 Bewertungen. Hast du eine Frage zu Metra Axxess AX-ADCH02 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AX-ADCH02

INSTALLATION INSTRUCTIONS

AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 6/26/18 INSTAX-ADCH02

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun, solder,

and heat shrink • Small flat-blade screwdriver

• Tape • Wire cutter • Zip ties

TABLE OF CONTENTS

Connections to be made

For models

without

an amplifier .......................3

For models

with

an amplifier ............................4

Installing & programming the AX-ADCH02

AX-ADBOX1 ...........................................................5

AX-ADBOX2 ..........................................................6

Adjusting the AX-ADCH02 .....................................7

Chrysler Data Interface2007-up*

APPLICATIONS

See inside front cover

• Provides accessory power (12-volt 10-amp)

• Maintains the retained accessory power (R.A.P.) feature

• Provides NAV outputs (parking brake, reverse, speed sense)

• Retains safety chimes

• Pre-wired ASWC-1 harness (ASWC-1 sold separately)

• Can be used in both amplified and non-amplified models

• Retains balance and fade†

• Retains Blind Spot Detection (if equipped)

• Micro “B” USB updatable

• AX-ADCH02 harness

• 4-pin harness with stripped leads

*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.

INTRODUCTION

The AX-ADCH02 harness is designed for, and must be used with, the

AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the

AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads

.

† To retain fade in amplified models, use the AX-ADBOX1

Produktspezifikationen