Metz 45 ct-1 Bedienungsanleitung

Metz Blitz 45 ct-1

Lies die bedienungsanleitung für Metz 45 ct-1 (7 Seiten) kostenlos online; sie gehört zur Kategorie Blitz. Dieses Handbuch wurde von 10 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 5.5 Bewertungen. Hast du eine Frage zu Metz 45 ct-1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/7
Modify a Metz 45ct1 flash to make it full manual.
Whe need:
a Stepped switch 12 positions (stappenschakelaar)
Black knob with a marking (knop met markering)
plastic box
Some diodecable and some wire ( diodekabel en montagedraad)
Resistors:
2,2M ohm
56K ohm
22K ohm
15K ohm
10K ohm
5K6 ohm (5,6K ohm)
3K9 ohm (3,9K ohm)
tulip connectors 1 male and 1 female
some pieces of shrinktube (krimpkous)
First remove the battery's.
If the flash was charged, discharge it by pressing the testbutton several times.
Remove the cover
Detach the small printboard.
Cut a piece of diode cable approx 5 inches and connect a female connector at one end.
Put the other end trough the hole (remove the small piece of transparent plastic).
Connect the two wires of the diodecable with the green and yellow wire.
eg. the center wire with the yellow wire and the outer wire with the green one or vice versa.
Make sure you shield the wires to avoid shortcuts. First i used thin shrinktubes to put over the
connected wires and a wider (red) piece of shrinktube to protect it all. This gives me a double
protection.


Produktspezifikationen

Marke: Metz
Kategorie: Blitz
Modell: 45 ct-1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metz 45 ct-1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten