Microchip HV809 Bedienungsanleitung
Seiten 11 Engels Nicht kategorisiert
Lies die Bedienungsanleitung für Microchip HV809 kostenlos online oder lade das PDF herunter. 18 Personen fanden diese Anleitung hilfreich. Frage zu diesem Modell? Stelle eine Frage
Supertex inc.
Supertex inc.
www.supertex.com
Doc.# DSAN-AN-H36
A040313
AN-H36
Application Note
HV809 EL Lamp Driver for Battery Powered
and Off-line Equipment
by Scott Lynch, Senior Applications Engineer
Introduction
The Supertex HV809 is designed to drive large lamps at
high brightness. It can operate from a rectied/ltered 120V
AC power line or from any DC source in the range of 50 to
200V. For use in battery powered applications, an external
DC-DC converter is required.
This application note is divided into two sections, portable
applications and off-line applications. Section I describes the
operation of the Supertex’s HV809 EL lamp driver for a battery
operated (4 AA cells) application to drive a 12.5in2EL lamp
to a brightness of 15ft-lm. Details are provided for designing
a high voltage output DC-DC converter. Applications can be
for PDA’s, GPS’s, hand held computers, and other portable
devices requiring high brightness EL backlighting. Section II
describes the HV809 operating from a 120V AC line to drive
a 100in2 EL lamp to a brightness of 20ft-lm. Applications can
be signage, courtesy lighting, and accent lighting.
Section I - Portable Applications
The basic circuit conguration is shown in Figure 1. There
are many different implementations in designing the DC-DC
converter. In this design, an inexpensive 555 timer IC was
used for the DC-DC converter. Details of the converter are
discussed in a later section.
Lamp Driver Circuit and Operation
The Supertex HV809 is capable of driving EL lamps of up to
350nF at 400Hz. Input supply can be any DC voltage source
from 50 to 200V. The HV809 supplies the EL lamp with an
AC square wave with a peak-to-peak voltage of two times
the input DC voltage.
The HV809 incorporates a lamp drive oscillator with frequency
controlled by a single resistor, REL-osc. The oscillator controls
the lamp driver output section, which consists of 4 transistors
arranged in a full bridge conguration as shown in Figure 2.
Figure 2: HV809 Lamp Driver
Figure 1: HV809 for Portable Applications
A1
A2
GND
REL
HVIN
VDD
OSC2
OSC1
HV809
DC-DC
Converter
CDD
REL
EL
Lamp
Batteries
HVOUT
VIN
Linear
Regulator
GND
HVIN
VDD
OSC2
OSC1
REL-Osc
Q
Q
Q
VA
Q
Logic
and
Osc
VB
Produktspezifikationen
| Marke: | Microchip |
| Kategorie: | Nicht kategorisiert |
| Modell: | HV809 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Microchip HV809 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Microchip
Microchip MCP6273 Bedienungsanleitung Microchip dsPIC33EP128GP504 Bedienungsanleitung Microchip AT89LP828 Bedienungsanleitung Microchip AT91RM9200 Bedienungsanleitung Microchip VSC8658 Bedienungsanleitung Microchip AT86RF233 Bedienungsanleitung Microchip PIC24FJ256GA108 Bedienungsanleitung Microchip GridTime_3000 Bedienungsanleitung
Beliebt in Nicht kategorisiert
Microchip SY88149CL Bedienungsanleitung Microchip PIC16F1508 Bedienungsanleitung Microchip UTC2000 Bedienungsanleitung