Mio Mivue 760D Bedienungsanleitung

Lies die bedienungsanleitung für Mio Mivue 760D (3 Seiten) kostenlos online; sie gehört zur Kategorie Dashcam. Dieses Handbuch wurde von 39 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 20 Bewertungen. Hast du eine Frage zu Mio Mivue 760D oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

M760D

STARVIS dual cam

Detachable GPS Rider dash cam Installation

Guide

Suggested installation location for

each accessory

Main deviceReference installation location

Example 1

Scooter

Example 2

Straddle dual-purpose motorcycle

WiFi

Avoid installing the Main

device at locations with

higher temperatures such

as next to the engine or

at the bottom of the

storage compartment, or

being covered by

raincoat; it is also

recommended to fix it on

the side using the buckle.

C. Front cam

B. GPS multifunction control box

A. Main device

D. Rear cam

If the Main device is

exposed (rail will fall

on it), be sure to

tighten the

anti-dismantle screws

of the memory card.

Avoid hiding the front

(the side with the logo)

of the Main device

under metal objects in

order to prevent poor

WiFi reception.

A.

To install the Main device at the front storage

compartment, the front and rear cams can be

switched around for installation.

A.

The Main device can be installed in the

toolbox space.

B.

The Main device can be installed on the side of

the storage compartment under the seat, but

avoid covering it with raincoats and resulting to

poor radiation.

Avoid attaching it at locations near the bottom

where heat source is emitted (the bottom of the

storage compartment is usually where the

engine and battery are installed).

C

B

A

D

A

A

B

Things you need to know before installation:

1. The following installation guide is for reference only due to different brands, model

types and personal usage habits; thorough discussion with vehicle mechanics is

recommended before performing installation.

3. The input of the M760D power cable is 12V/2A; please confirm whether the vehicle’s

circuit voltage and current can bear the load in order to prevent the fuse of the

motorcycle to burn due to overload. Some vehicle models have reserved backup

power; please use a multimeter to confirm whether the backup power connector can

be used before installation.

5. Before officially installing the dash cam, confirm that the BMW connector of each

cable segment is properly tightened and wrapped with thermal casing or waterproof

tape in order to reduce the scratching of internal objects or generating strange noises

due to vibrations from the motorcycle.

6. To install it on the Gogoro electric scooter, please discuss with Gogoro’s genuine

mechanic to confirm whether the charging port can supply 12V/2A power before

installation.

2. Before official installation, please connect the circuits of all components (including

front and rear cams, Main device, GPS multifunction control box and 12V power cable);

first connect the 12V power cable to the battery or fuse and confirm that the functions

of each component can be successfully turned on, and then hide the cables and

perform installation.

4. After the power of the motorcycle is turned on, it takes approximately 10-12 seconds

for power to be supplied to the dash cam and turned on; at this time, will blue light

flash on the GPS multifunction control box.* If red light flashes it means something is

abnormal, and the cable segments must be checked to see if they are properly and

tightly connected.

Produktspezifikationen