PAC OS-2X Bedienungsanleitung

Lies die bedienungsanleitung für PAC OS-2X (3 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 23 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 9 Bewertungen. Hast du eine Frage zu PAC OS-2X oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

OS-2X

Radio Replacement Interface with OnStar Retention for

General Motors Vehicles

Pacic Accessory Corporation

® | Ontario, Ca. 91761 | Ph. 866-931-8021 | support@pac-audio.com

©2014 Pacic Accessory Corporation

www.pac-audio.com

Rev. 050714

Pifi ACti

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The OS-2X interface allows the replacement of a factory radio in select General Motors vehicles with Class II radios.

Using this interface will retain factory features such as OnStar, warning chimes, Rear Seat Controls (RSC), Rear Seat

Entertainment (RSE) and the BOSE amplier when the original radio is removed. The OS-2X also provides data bus

driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and

parking brake.

1. The aftermarket radio must have an auxiliary input in order for the factory RSE audio to be retained through the cabin speakers.

2. RSC buttons that are identical to the SWC will mimic the SWC functon for function.

3. The interfaces accessory output is only rated at 10 amps. It is designed for the new aftermarket head unit ONLY.

4. For Bose systems, the recommended line level input is 2-4 volts from the aftermarket radio.

5. To prevent over driven audio when installing into a vehicle with a Bose system and the aftermarket radio does not have low level outputs

then an LOC (part # LP3-2) is recommended to match the input voltage or you can create an audio attenuation circuit (see diagram 2 below

for audio attenuation wiring).

6. To prevent ground loop or engine noise when installing aftermarket radios that use a common ground on the outer shield of the low level

outputs will require a ground loop isolator (part # LPGL-2)

Red / WhiteParking Brake

Output (-)

Purple / WhiteVehicle Speed

Output

Blue Not Used

Blue / WhiteAmp Turn On Input

Orange / WhiteIllumination Output

(+)

Green Reverse Output (+)

Brown LoopMute Loop - See

installation note 5.

Aftermarket Radio Connections

YellowBattery +12v

Black Ground

Red Accessory Output

White Front L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

Green Rear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Wiring

Page 1

Aftermarket

Radio

Connections

Vehicle

Connections

Connect to SWC

Interface. Program

for Version 2.

OS-RADPWRAUDIO

CMX

chime module

SWI nnectCo ion

RSE Audio Harness

Produktspezifikationen