POLARIS SpaWand Bedienungsanleitung

Lies die bedienungsanleitung für POLARIS SpaWand (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 15 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 8 Bewertungen. Hast du eine Frage zu POLARIS SpaWand oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

1. Rotate the End-Cap Assembly

until arrows appear in the wide

openings of the End-Cap Base.

2. Gently pull the End-Cap

Assembly and filter screen out

of the End-Cap Base.

3. Grasp the black band at the

base of the screen. Do not

grasp the filter screen. Gently

rotate the End-Cap Assembly

toward you (about 1/8 turn)

until you feel it stop.

4. Remove the filter screen from

the End-Cap Assembly and

shake out the debris.

5. Line up the notches on the

inside of the black band with

the locking tabs on the End-Cap

Assembly; slide the filter screen

onto the assembly and gently

rotate the assembly away from

you (1/8 turn) until the

filter screen locks into place.

Rinse out any fine silt and flush

any grit from the assembly.

6. Insert the filter, with End-

Cap Assembly, back into the

SpaWand End-Cap Base. Line

up the arrows on the End-Cap

Assembly to appear in the wide

openings of the End-Cap Base.

Rotate the End-Cap Assembly

until your hear a “click” and the

arrows are no longer visible.

The Polaris SpaWand, SpaWand Pro, and SpaWand ProXL operate by drawing in debris and water as you pull the

handle. When you push the handle in, the water flows out and the dirt, silt and debris are trapped inside the filter.

You must first prime the SpaWand by submerging the nozzle in your spa or pool and pumping the handle in and out

several times. This action removes any air trapped in the SpaWand.

The SpaWand comes with two different nozzles that have three specific uses. The Dual Purpose Nozzle fits directly

onto the SpaWand End-Cap Base and flips to become either a narrow or bell end. The Wide Sweep Nozzle fits over the

narrow end of the Dual Purpose Nozzle.

To clean the filter:

A. To remove rocks and large

debris from the spa bottom,

point the narrow end of the

Dual Purpose Nozzle near

the debris and then pull out

the handle.

B. To remove floating debris,

position the bell end of the Dual

Purpose Nozzle over the debris.

Sink it below the surface of the

water and pull out the handle.

C. To remove dirt and silt from the

spa bottom, position the Wide

Sweep Nozzle in front of the

dirt, with the handle pushed in.

Sweep the nozzle forward while

pulling out the handle.

Caution: Do not scrape SpaWand nozzles against acrylic spas.

SpaWand

®

Instructions

End-Cap Base

End-Cap Assembly

End-Cap Base

End-Cap Assembly

End-Cap Base

End-Cap Assembly

Wide Sweep NozzleDual Purpose Nozzle, Narrow EndDual Purpose Nozzle, Bell End

End-Cap Base

End-Cap Assembly

End-Cap Base

End-Cap Assembly

End-Cap Base

End-Cap Assembly

End-Cap Base

End-Cap Assembly

Produktspezifikationen